658894
38
Zoom out
Zoom in
Previous page
1/98
Next page
OPERATION
37
Operator Observations
Constant attention should be paid to the following
points during operation:
Engine oil pressure lamp will come on in case of
low engine oil pressure. Stop engine immediately.
Battery charge lamp will come on if battery is not
being charged properly. Stop engine and investigate
cause.
Coolant temperature gauge needle will indicate
H(hot) in case of over-heated engine. Stop engine,
allow to cool, and investigate cause.
Fuel level should not be allowed to (E) empty as
running out of fuel may result with need to bleed air
from fuel system.
CAUTION: DO NOT attempt to service
Tractor with engine running or hot. Allow
to cool.
NOTE: Refer to “Trouble-Shooting” when defect is
indicated, to assist locating problem.
Starting Circuit Operation
Tractor is equipped with a switch system to protect
the operator.
To permit Tractor to be started (starter motor to oper-
ate), ALL the following is required:
Range Gear Shift Lever in Neutral.
PTO clutch lever in disengage position.
WARNING: Neutral switch system is
installed for your protection. DO NOT
bypass or modify the neutral start switch
system. If the neutral start switch system
does not operate properly as detailed
above, contact your Dealer immediately
and have the system repaired.
Periodically check that the starting circuit is function-
ing correctly. The procedure for this is check list
as follows.
1. Check that there are no bystanders around the trac-
tor should it inadvertently start.
2. Depress the brake pedal. Attempt to start the tractor
with the range gear and PTO in neutral position.
The Tractor should start.
3. Depress the brake pedal. Attempt to start the Trac-
tor with the range gear engaged and the PTO in ON
position. The Tractor should NOT start.
4. Depress the brake pedal. Attempt to start the Trac-
tor with the range gear in neutral and the PTO
engaged. The Tractor should NOT start.
If starting system is not working correctly it must be
repaired immediately by your Dealer.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Iseki TXG237 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Iseki TXG237 in the language / languages: English as an attachment in your email.

The manual is 10,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info