658894
36
Zoom out
Zoom in
Previous page
1/98
Next page
OPERATION
35
Normal Starting
FIGS. 4-1 & 4-2: To start engine proceed as follows:
1. Apply parking brake.
2. Place range shift lever in neutral position.
3. Make sure PTO clutch lever is in disengaged position.
WARNING: Range shift lever must be
placed in neutral position and PTO clutch
lever must be in disengaged position.
4. Do not move hydrostatic pedal, it must be in neutral
position.
5. Set position control lever (3-position hitch) in the
down position.
6. Turn main switch to the right to “glow” position for
5-10s until indicator glows. Glow monitor lights up,
but it dose not turn off if the glow is ready.
7. Set hand throttle lever at half to fully open position.
8. Turn main switch to “on” position for 1-2s, then
turn to “start” position. Release switch the moment
engine starts.
9. Once engine runs smoothly, set engine speed
to approximately 1,500 rpm to allow engine and
hydraulic system to warm for several minutes. DO
NOT LOAD COLD ENGINE.
WARNING: Range shift lever must be
placed in neutral position to actuate
neutral switch and permit operation of the
starter motor.
FIG. 4-3: Battery charge indicator lamp, 1, and engine
oil pressure lamp, 2, on indicator light strip should
go out when the engine starts. If either light remains
lit, STOP ENGINE IMMEDIEATELY and investigate
source of problem.
NOTE: If Engine will not start and run after several
attempts, refer to “Maintenance” section in
this book and bleed any air that may be pres-
ent in the fuel system.
Normal Starting
Battery Oil lamp
FIG. 4-1
FIG. 4-2
FIG. 4-3
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Iseki TXG237 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Iseki TXG237 in the language / languages: English as an attachment in your email.

The manual is 10,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info