509862
17
Zoom out
Zoom in
Previous page
1/38
Next page
En
13
When exiting the ‘Filter List sub-menu, a new menu will be shown ‘Conrm
changed?’ Press the <ENTER>-key to validate all programs just be selected to
be ltered away or press the <EXIT>-key to discard the settings.
After a few seconds, the ltered TS will be generated and delivered to the speci-
ed destination(s).
Ethernet
The menu is shown only when the TS/IP streaming is installed and the board is
set to “IP Out”.
The TS/IP Ethernet connector could also be congured as the output of the trans-
port stream over IP. The parameters listed below must be set to appropriate
values for the network that the transport stream over IP is broadcasted.
Stream IP Addr: Enter the IP address for streaming IP output of the unit.
Stream Netmask: Enter the network sub mask for the subnet to which the unit is
connected for IP streaming trafc.
Stream Gateway: Set the gateway for the network to which the unit is connected
for IP streaming trafc.
Stream Mac Address: Factory-set MAC addresses are guaranteed to be unique.
Therefore, you cannot congure the address.
Gateway Mac address: Set the MAC address of your gateway. you can leave
it as ff:ff:ff:ff:ff:ff
Protocol: Select the protocol for multicast: UDP or RTP.
TS Pkts per UDP: Set the number of the TS packages encapsulated in one UDP
package. The valid range goes from 1 to 7.
Time to Live: Set the number of the routers over which the TS over IP can be
transmitted. The valid range goes from 1 to 255.
Type of Service: Select the type of service. There are: Normal, Min Monetary
Cost, Max Reliability, Max Throughput or Min Delay optional.
Source: Select the source of the transport stream over IP streaming output.
There are 4 type of source optional: ASI Input, CI De-encrypted, TUNER, Mux TS
(note the Mux TS is showed only when the Mux/Filter function block is enabled
and turned on. The Mux TS indicates not only the after-multiplexed TS when Mux
is enabled, but also the after-ltered TS when the lter is enabled.)
After the operation, the selected transport stream will be delivered to the TS / IP
function block for further operation.
Mode: Select the mode of IP stream, you can select DVB or IPTV.
DVB mode: The transport stream which comes from the ‘source’ selected in the
previous step will be packed into IP Stream directly. The IP stream will carry all
programs, and this IP stream will be delivered to specied Multicast or Unicast
IP address.
IPTV mode: The transport stream which comes from the ‘source’ selected in the
previous step will be de-Muxed to several single programs, and each program is
packed into one IP stream. Each IP stream is then being delivered to specied
Multicast or Unicast IP address. You can congure up to 32 IPTV channels.
Multicast Setup: Use the <ENTER>-key to enter sub-menu. The sub-menu is
different according to different ‘mode’ selected in previous step.
DVB mode
Multicast IP: Enter the IP address of the IP stream for the transport stream over
IP output. You can congure the IP stream output mode in Multicast or Unicast.
Multicast could be established by setting Multicast IP address in the range be-
tween 239.255.255.255 and 224.0.0.0.
Unicast could be established with the same settings of Multicast, but there is a
difference. The IP address should NOT be set in the range between 224.0.0.0
and 239.255.255.255. Although the display is ‘Multicast IP’ on the rst row, the
stream itself is Unicast. The IP address of the receiving device (may be PC with
VLC) needed to be set to the same unicast address as the one on IDLV-4000P.
Please don’t use DHCP to get a dynamic IP address for the receiving device.
Multicast UDP Port: Enter the UDP port number of the TS over IP stream out-
put.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inverto IDLV-4000P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inverto IDLV-4000P in the language / languages: English as an attachment in your email.

The manual is 2,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info