571938
10
Zoom out
Zoom in
Previous page
1/20
Next page
Page 10 of 20 pages
Smoke flue regulating damper (16).
Soot door (17).
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are fitted correctly. Check that all insula-
tion plates of the combustion chamber have been properly placed, i.e. that the bottom plate is horizontal
and that the side plates are vertical and reach all the way up to the steel sides of the combustion chamber
and down to the bottom plate.
Vertical cross-section of the stoves (Drawing B):
The smoke shelf (5). To be placed on top of the steel rail and on the holders in the sides.
Two-piece smoke defector plate (6). Each half is hung on the hooks located beneath the top plate. The two
halves join in the holders behind the air pipe. Once the stove has been installed, twist the protection off
the two hooks by using pliers or a screwdriver.
Removable rear plate (2a). This must always be mounted if the stove is placed next to a combustible
wall.
Removable heat shield (2b) - HWAM 3520. This must always be mounted if the stove is placed next
to a combustible wall.
Loose heat shield (8) under the ash pan. This can be used as a lid when the ash pan is removed for
emptying. This must always be mounted when the stove is burning
Connection of the HWAM® SmartControlTM
Before using the stove it must be connected to power. See the instructions in the separate manuals for
the app IHS SmartControlTM or in the Quickguide in order to connect to stove with the app and the
wireless room temperature sensor.
Chimney
The chimney is the “engine” of the stove and it is crucial for the functioning of the woodburning stove.
The chimney draft provides a partial vacuum in the stove. This vacuum removes the smoke from the
stove, sucks air through the dampers in the Air box for the so-called glass pane rinse which keeps the
glass free of soot, and for the combustion.
The chimney draft is created by the differences in temperature inside and outside the chimney. The higher
the temperature within the chimney, the greater the draft (a brick chimney takes longer to warm up than
a steel chimney). On days where the weather and wind conditions create insufficient draught inside the
chimney, it is even more important to warm up the chimney as quickly as possible. The trick is to quickly
get some flames going. Split the wood into extra fine pieces, use an extra firelighter, etc.
If the stove has not been used for a longer period, it is important to check that the chimney pipe is not
blocked. It is possible to connect several devices to the same chimney. However, it is important to first
check the applicable rules.
Chimney sweeping
To prevent the risk of chimney fires, the chimney must be cleaned every year. The flue duct and the smoke
chamber above the baffle plate must be cleaned together with the chimney. If the chimney is too tall to
be cleaned from above, it must be equipped with a soot door.
In case of a chimney fire and overheating, the HWAM® SmartControlTM will enter a security mode and
automatically adjust all dampers in the Air box, effectively quenching the fire. Do not open the door for
the burning chamber, since that might cause the fire to rekindle. Contact the fire brigade. After a fire, the
stove should be checked by a chimney sweep before use.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam 3520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 3520 in the language / languages: English as an attachment in your email.

The manual is 1.57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 3520

Hwam 3520 User Manual - English - 56 pages

Hwam 3520 User Manual - German - 44 pages

Hwam 3520 User Manual - Dutch - 32 pages

Hwam 3520 User Manual - Danish - 56 pages

Hwam 3520 User Manual - French - 32 pages

Hwam 3520 User Manual - Italian - 44 pages

Hwam 3520 User Manual - Swedish - 56 pages

Hwam 3520 User Manual - Spanish - 44 pages

Hwam 3520 User Manual - Norwegian - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info