595368
22
Zoom out
Zoom in
Previous page
1/48
Next page
22 – English
OPERATING
Transport and storage
The machine is heavy and can cause serious crush
injuries. Take extra care when loading it onto or off a
vehicle or trailer.
Use an approved trailer to transport the machine.
Check and observe local road traffic regulations before
transporting or driving the machine on roads.
To secure the machine on the trailer, two approved tension
belts and four wedge shaped wheel blocks should be used.
Engage the parking brake and tie the tension belts around
the front and rear brackets.
Secure the machine by tensioning the belts towards the
back and the front of the trailer respectively.
Place the wheel blocks in front of and behind the rear
wheels.
Transport with engine off
Hydraulic pressure must be released in order for the ride-on
mower to be moved when the engine is shutoff.
The hydraulic pressure is opened and closed with a bypass
valve.
Bypass valves
If you try to drive the machine without hydraulic pressure, it
will not move. The drive on the axle is disengaged if one valve
is open.
The P 520D and the P 525D has two valves, one valve for the
front axle and one for the rear axle.
Bypass valve rear axle
The hydraulic pressure is released by opening the locking
nut (1) 1/4-1/2 turn anti-clockwise, then the bypass valve
(2) 2 turns.
The hydraulic pressure is switched on by closing the
valve. Close the valve nut (2) fully before tightening the
locking nut (1).
Bypass valve front axle
The hydraulic pressure is released by opening the locking
nut (1) 1/4-1/2 turn anti-clockwise, then the bypass valve
(2) 2 turns.
The hydraulic pressure is switched on by closing the
valve. Close the valve nut (2) fully before tightening the
locking nut (1).
Winter storage
At the end of the season, or if the machine is going to stand
idle for more than 30 days, it should immediately be made
ready for storage.
For transport and storage of fuel, see the section "Fuel
handling".
To prepare the machine for storage follow these instructions:
Carefully clean the machine, especially under the cutting
unit.
Touch-up paint damage to avoid rust.
Inspect the machine for worn or damaged parts and
tighten loose screws and nuts.
Change the engine oil, and take care of the waste oil.
Fill fuel tank.
Grease all grease nipples, joints and axles.
Remove the battery. Clean it, charge it, and store it in a
cool place.
Store the machine in a clean and dry place and cover it
over for extra protection.
Guard
There is a cover to protect your machine during storage or
transport. Contact your dealer for a demonstration
IMPORTANT! The parking brake is not sufficient to lock the
machine during transport. Ensure you secure the machine
firmly to the transporting vehicle.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna P 520D - 2015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna P 520D - 2015 in the language / languages: English as an attachment in your email.

The manual is 12,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna P 520D - 2015

Husqvarna P 520D - 2015 User Manual - German - 48 pages

Husqvarna P 520D - 2015 User Manual - Dutch - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info