595368
24
Zoom out
Zoom in
Previous page
1/48
Next page
24 – English
STARTING AND STOPPING
Starting when cold
If the engine fails to start due to the cold, repeat ignition and
attempt to re-start. Start gas or ether must not be used.
For more information about winter fuel, please see 'Fuel
handling'.
Starting the engine with a weak
battery
If the battery is too weak to start the engine, it should be
recharged.
When jump leads are used for emergency starting, follow the
procedure below:
Connecting the jump leads
1 Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any
of the ends against the chassis.
2 Connect one end of the black cable to the NEGATIVE pole
(-) on the fully charged battery.
3 Connect the other end of the black cable to a good
CHASSIS EARTH, away from the fuel tank and the
battery.
Remove the cables in the reverse order
The BLACK cable is removed from the chassis and then
the fully charged battery.
Finally the RED cable from both batteries.
Braking
Release the drive pedals. The machine slows and is stopped
by the drive system. Do not use the parking brake as the drive
brake.
Quicker braking is possible if you press down the drive pedal
for the opposite direction.
Stop the engine
Always park the machine on a level surface with the engine
OFF.
Preferably allow the engine to idle for a minute to obtain
normal working temperature before stopping it if it has been
working hard.
1 Stop the blades by pressing in the control for driving the
cutting unit.
2 Apply the parking brake by moving the handle downward.
3 Lift the cutting unit with the hydraulic lifting lever.
4 Move the throttle control to the MIN. position.
5 Turn the ignition key to ”OFF”-position.
IMPORTANT! At temperatures below 0 ° C, the machine
must be warmed up for at least 10 minutes for the hydraulic
oil and transmission to get hot. Otherwise there is a risk of
the transmission breaking down thereby reducing the
service life of the transmission.
!
WARNING! Lead-acid batteries produce
explosive gases. Avoid sparks, open flames
and smoking close to batteries. Always wear
protective glasses in the vicinity of batteries.
IMPORTANT! Your Rider is equipped with a 12-volt system
with negative earth. The other vehicle must also have a 12-
volt system with negative earth. Do not use your Rider
battery to start other vehicles.
!
WARNING! Never connect the negative
terminal of the fully-charged battery to, or in
the vicinity of, the negative terminal of the
discharged battery. Hydrogen gas may be
present with risk of explosion.
1
1
2
3
IMPORTANT! Never use a boost charger/start booster.
Use only conventional battery chargers. Always disconnect
the charger before starting the engine. So called boost
chargers/start boosters must never be used. These will
often increase the voltage (instead of the current) to
generate the power needed to start the engine. This
increase in voltage will damage the electrical system.
!
WARNING! Never use the reverse pedal to
brake the machine without the cutting unit
mounted. Risk of the machine overturning.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna P 520D - 2015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna P 520D - 2015 in the language / languages: English as an attachment in your email.

The manual is 12,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna P 520D - 2015

Husqvarna P 520D - 2015 User Manual - German - 48 pages

Husqvarna P 520D - 2015 User Manual - Dutch - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info