6904.2007 TR10A041-C RE
7.10 MENU A – maximum force (see fig. 31 )
In this menu, the maximum force limit is set.
Display Maximum force limit
Note
Increasing the force value (parameter greater than 0) is only
possible when parameter 3 in menu J has been selected.
Press the PRG button to return to normal operation
(menu 0).
8 ERROR MESSAGES AND WARNINGS
(see page 71)
9 DISMANTLING
Have the garage door dismantled and disposed of by
a specialist.
10 TERMS OF WARRANTY
Warranty period
In addition to the statutory warranty provided by the
dealer, we provide the following warranty of parts from
the date of purchase:
a) 5 years on operator mechanics, motor and motor
control system
b) 2 years on radio equipment, accessories and special
systems
There is no warranty on consumables (e.g. fuses, batte-
ries, lamps). Claims made under the warranty do not
extend the warranty period. Following the supply of
replacement parts and repairs, the warranty period is six
months or at least the remainder of the warranty period.
Prerequisites
A claim under this warranty is only valid for the country
in which the equipment was bought. The product must
have been purchased through our authorised distribution
channels. A claim under this warranty exists only for da-
mage to the object of the contract itself. Reimbursement
of expenditure for dismantling and installation, testing of
corresponding parts, as well as demands for lost profits
and compensation for damages, are excluded from the
warranty. The receipt of purchase substantiates your
right to claim under the warranty.
Performance
For the duration of the warranty we shall eliminate any
product defects that are proven to be attributable to a
material or manufacturing fault. We pledge to replace
free of charge and at our discretion the defective goods
with non-defective goods, to carry out repairs, or to
grant a price reduction as reimbursement.
Excluded is damage due to:
- improper installation and connection
- improper putting into service and operation
- external influences such as fire, water, abnormal
weather conditions
- mechanical damage due to accidents, dropping,
impact
- negligent or deliberate destruction
- normal wear or deficient maintenance
- repair by non-qualified persons
- use of non-original parts
- removal or defacing of the type plate
Replaced parts become our property.
11 TECHNICAL DATA
Voltage: 230/240 V, 50/60 Hz
Stand-by: Approx. 4.5 W
Protection category: For dry rooms only
Automatic Automatically programmed
cut-out: separately for both operational
directions.
End-of-travel
cut-out/
force limit: Self-learning, non-wearing,
since no mechanical switches
are used. Additionally integrated
excess travel stop of approx.
60 s. Automatic cut-out re-
adjusts during each door cycle.
Rated load: See type plate
Push and
pull force: See type plate
Motor: DC motor with Hall sensor
Transformer: With thermal overload
protection
Connection: Connection technique without
screws for external equipment
with safe extra-low voltage
of 24 V DC, e.g. internal and
external buttons for impulse
control
Special functions: - Stop/off switch can be
connected
- Photocell or closing edge
safety device can be
connected
- Options relay for warning
light, additional external
lighting can be connected
via the HCP bus adapter
Quick release: In the event of a power failure
actuated from the inside via a
pull rope
➤
ENGLISH
