66 04.2007 TR10A041-C RE
Operator lighting by radio signal, external push-button
not active
5 minutes
10 minutes
15 minutes
Radio function of the 2nd channel
Operator lighting
Partial opening
Press the PRG button to return to normal operation
(menu 0).
6.3 MENU 0 – normal operation
In normal mode, the garage door operator operates
with impulse sequence control, activated via an external
push-button or a learned radio code:
1st impulse: door travels towards the end-of-travel
position
2nd impulse: door stops
3rd impulse: door travels in the other direction
4th impulse: door stops
5th impulse: door travels towards the end-of-travel
position selected with the first impulse
etc.
6.3.1 Behaviour of the garage door operator after
2-3 fast-opening cycles in succession
Note
The motor of the garage door operator features thermal
overload protection.
If within 2 minutes 2-3 fast-opening cycles take place in
succession, this safeguard reduces the speed, i.e. travel in
both the OPEN and CLOSE directions proceeds at the
same speed. After a rest period of a further two minutes,
the next opening cycle is performed at fast speed again.
7 SPECIAL MENUS
7.1 Selecting the special menus
To access the special menus (menu 3 - menu A), simul-
taneously press the OPEN button () and the CLOSE
button () in menu 2. The service menus can be selected
via the PRG button.
7.2 General information on the special menus
(Menu 3 – menu A)
Upon selection, the menu number remains displayed for
a short period. Subsequently, the first active menu para-
meter is shown flashing slowly. Press the OPEN button
() or the CLOSE button () to page through the menu.
The active parameter or parameters are indicated by a
glowing decimal point.
To change a parameter, press and hold the PRG button
until the display flashes rapidly. Press the OPEN button
() and the CLOSE button () to page through the menu.
The active parameter is indicated by a glowing decimal
point. To activate a parameter, press the PRG button until
the decimal point lights up. If the PRG button is released
prematurely, this calls up the next menu. If no button is
pressed and the operator has completed the learning
process, the control system automatically returns to nor-
mal operation (menu 0).
7.2.1 7-segment display when changing from the
customer menu to the special menus
Note
When changing to the special menus, depending on the
current setting in menu 2, a number between "0" and "6"
flashes in the 7-segment display.
7.2.2 7-segment display after selecting a special menu
Note
After selecting a special menu, a number between 0…9
can flash in the 7-segment display, depending on the menu.
This number indicates the (first) active parameter
7.3 MENU 3 – automatic timed closing (see fig. 24 )
Note
Automatic timed closing can only be activated when at
least one safety device is active (menu 4).
Display Automatic timed closing
not activated
after 10 seconds
after 20 seconds
after 30 seconds
after 45 seconds
after 60 seconds
after 90 seconds
after 120 seconds
after 150 seconds
after 180 seconds
Note
If the operator receives an impulse during automatic timed
closing (menu 3, parameter greater than 0), then the door
stops and opens again.
Press the PRG button to return to normal operation
(menu 0).
ENGLISH
