78142
13
Zoom out
Zoom in
Previous page
1/108
Next page
English
13
Table 2 Charging time (At 20°C)
Charger
Battery
UC18YG UC18YK
EB912S, EB914S, BCC915,
EB1212S, EB1214S,
BCC1215, EB1412S,
EB1414S, BCC1415,
EB1814SL, BCC1815
Approx.
30 min.
Approx.
50 min.
EB9B, EB1220BL, EB14B,
EB1820L
Approx.
50 min.
Approx.
80 min.
The pilot lamp goes o to indicate that the battery is fully
charged.
The battery charging time becomes longer when a
temperature is low or the voltage
of the power source is
too low.
<UC18YG>
When the pilot lamp does not go o even if more than 120
minutes have elapsed after starting of the charging, stop
the charging and contact your HITACHI AUTHORIZED
SERVICE CENTER.
CAUTION
If the battery is heated due to direct sunlight, etc.,
just
after operation, the charger pilot lamp may not
light up. At that time, cool the batteryrst, then start
charging.
3. Disconnect the charger’s power cord from the
receptacle
4. Hold the charger rmly and pull out the battery
NOTE
After charging, pull out batteries from the chargerrst,
and then keep
the batteries properly.
Regarding electric discharge in case of new batteries,
etc.
As the internal chemical substance of new batteries and
batteries that have not been used for an extended period
is not activated, the electric discharge might be low when
using them therst and second time. This is a temporary
phenomenon, and
normal time required for recharging
will be restored by recharging the batteries 2 3 times.
How to make the batteries perform longer.
(1) Recharge the batteries before they become completely
exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery. If
you continue to use the tool and exhaust the electric
current, the battery may be
damaged and its life will
become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use.
If such a battery is recharged immediately after use, its
internal chemical substance will deteriorate, and the
battery life will be shortened. Leave the battery and
recharge it after
it has cooled for a while.
<UC18YGH>
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to the
receptacle.
When connecting the plug of the charger to
a receptacle, the pilot lamp will blink in red
(At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it contacts
the bottom of the charger and checking the polarities as
shown in Fig. 4.
CAUTION
If the batteries are inserted in the reverse direction, not
only recharging will become impossible, but it may also
cause problems in the charger such as
a deformed
recharging terminal.
3. Charging
When inserting a battery in the charger, the pilot lamp will
light up continuously in red.
When the battery becomes fully recharged, the
pilot lamp will blink in red (At 1-second intervals).
(See Table 3)
(1) Pilot lamp indication
The indications of the pilot lamp
will be as shown in
Table 3, according to the condition of the charger or the
rechargeable battery.
Table 3
Indications of the pilot lamp
Pilot lamp
(red)
Before
charging
Blinks
Lights for 0.5 seconds. Does not light for 0.5
seconds. (o for 0.5 seconds)
While
charging
Lights
Lights continuously
Charging
complete
Blinks
Lights for 0.5 seconds. Does not light for 0.5
seconds. (o for 0.5 seconds)
Overheat
standby
Blinks
Lights for 1 second. Does not light for 0.5
seconds. (o for 0.5 seconds)
Battery overheated.
Unable to charge.
(Charging will commence
when battery cools)
(2) Regarding the temperature of the rechargeable battery.
The temperatures for rechargeable batteries are as
shown in the table below, and batteries that have become
hot should be cooled for a while before being recharged.
000Book_DS9DVF3_WETha.indb 13000Book_DS9DVF3_WETha.indb 13 2012/06/06 8:46:142012/06/06 8:46:14
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi DS 12 DVF 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi DS 12 DVF 3 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 7,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hitachi DS 12 DVF 3

Hitachi DS 12 DVF 3 User Manual - English, Danish, Swedish, Norwegian, Finnish - 46 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info