700148
23
Zoom out
Zoom in
Previous page
1/28
Next page
Switch position = LP/BP
23
OPERATING INSTRUCTIONS
INTERCONNECTION EXAMPLE: 2 Amplifiers (X4-Models) in Link-Mode
1. Connect Stereo RCA output (L/R or SUB OUT)
of the headunit with the LINE INPUT L/R of the
amplifier 1.
Connect the bass remote controller
and the remote terminal on the
MASTER amplifier (REMOTE IN)
with the enclosed cable .
Switch position = MASTER
X4-AMPLIFIER 1
Remote wire REM Remote wire REM
Remote wire REM
2. Connect Stereo RCA output (LINE OUTPUT)
of the MASTER amp with the LINE INPUT of the
amplifier 2.
1.
2.
Use the enclosed Link-Cable to link the Remote Ports.
X4-AMPLIFIER 2
Subwoofer
1 – 8 Ohms
Kickbass
1 – 8 Ohms
LINK-MODE
Unlike the GENERATION X4 MASTER/SLAVE Mode this interconnection example works also with other HIFONICS X4-AMPLIFIERS.
This interlinking is continuously expandable with additional amplifiers (Daisy Chaining).
LINE OUT SIGNAL
The provided audiosignal on the LINE OUTPUTS is a linear unmodified fullrange signal, which is suitable to trigger any additional amplifier.
REMOTE-BRIDGE
But to use the REMOTE BRIDGE function, you need to interlink two HIFONICS X4-AMPLIFIERS with eachother. This means the BASS
REMOTE controller must be connected on X4-AMPLIFIER 1 (REMOTE IN). Then use the enclosed bass remote cable from Amplifier 2
and interlink the X4-AMPLIFIER 1 (REMOTE OUT) with X4-AMPLIFIER 2 (REMOTE IN). Now you are able to control both amplifiers with
just one bass remote controller.
NOTE: Don’t use the REMOTE BRIDGE wire in MASTER/SLAVE mode.
SETTINGS
All settings like LEVEL, LOW PASS, SUB SONIC, PHASE SHIFT and EXTENDED BASS CONTROL must be adjusted on each amplifier
separately. Please note the descriptions on page 20 or refer to the owner’s manual from the used amplifier.
Kickbass
1 – 8 Ohms
For example X4-COLOSSUS in STEREO-MODE
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics X4-Atlas at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics X4-Atlas in the language / languages: English, German as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info