700148
22
Zoom out
Zoom in
Previous page
1/28
Next page
22
OPERATING INSTRUCTIONS
INTERCONNECTION SUBWOOFER
• Connect the Subwoofer terminals with the speaker outputs (SPEAKER OUTPUT + / -) of both amplifiers by using appropriate wires.
Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
Please ensure, that the total impedance load of subwoofer is not lower than described above.
Too low impedance cause high temperature and will shut down the amplifier operation.
INTERCONNECTION EXAMPLE: 1 Subwoofer with a Dual-Voicecoil
SLAVE
MASTER
Subwoofer Voice Coil 2
1 – 8 Ohm
Subwoofer Voice Coil 2
1 – 8 Ohm
INTERCONNECTION EXAMPLE: 2 Subwoofers with Single-Voicecoils
SLAVE
MASTER
Subwoofer 1
1 – 8 Ohm
INTERCONNECTION EXAMPLE: 1 Subwoofer with a Single-Voicecoil
SLAVE
MASTER
Subwoofer
2 – 8 Ohm
MASTER/SLAVE Link
like described on page 21.
MASTER/SLAVE Link
like described on page 21.
MASTER/SLAVE Link
like described on page 21.
Subwoofer 2
1 – 8 Ohm
The Impedance may not be lower than 2 ohms.
The negative cable from the MASTER amplifier must
be connected at the negative pole SLAVE amplifier.
The subwoofer on
the SLAVE amp needs
to be connected with a
converse polarity.
The subwoofer voice coil
on the SLAVE amp needs
to be connected with a
converse polarity.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics X4-Atlas at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics X4-Atlas in the language / languages: English, German as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info