741834

Hendi 225165 Manual

7
Zoom out
Zoom in
Previous page
1/112
Next page
7
EN
4.4 CONNECTION OF POWER CABLE
The terminal board is on the rear panel of the ap-
pliance. Open the terminal board cover by obtain-
ing leverage with a screwdriver on the two side fi ns.
Loosen the cable gripper screw and allow the cable
to pass through it. Arrange the conductors so that
the earth conductor is the last to detach from its
terminal if the cable goes into a state of faulty trac-
tion. Connect the phase conductor to the terminal
marked with the letter “L”, the neutral conductor
to the terminal marked with the letter “N” and the
earth conductor to the terminal marked with the
symbol . Tighten the ring-nut of the cable gripper
and close the terminal board cover. The appliance
must be connected to an equipotential system
whose effi ciency must fi rst be checked according
to current legal regulations. This connection must
be made between different appliances by using the
appropriate terminal marked with the symbol .
The equipotential conductor must have a minimum
diameter of 2,5 mm
2
. The equipotential terminal is
at the rear of the appliance.
N
230V
L2 L1 N
400V / 2N
L2 L1
4.5 SAFETY THERMAL BREAKER
The appliance has safety thermal breaker. It pro-
tects against excessive dangerous over-tempera-
tures which could be accidentally generated inside
the appliance. If the device is tripped, it interrupts
electrical power to the appliance and thus prevents
it from operating.
5. USE INSTRUCTIONS (FOR THE USER)
This appliance is not intended for use by persons
(including children) with reduced phycal, sensory
or mental capabilities, or lack of experience and
knowledge. Unless they have beengiven supervi-
sion or instruction concerning use of appliance by
a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
For fi rst use, we advise you to let the appliance to
run load-free at maximum temperature for about
one hour. In this way, any unpleasant smells due
to thermal insulation and residual work grease are
eliminated.
This appliance must be used solely for the purpose
for which it was expressly designed, i.e. cooking
foods in the oven. Any other use is considered un-
suitable.
The appliance can be used: for all oven cooking of
deserts, pizzas, meat, fi sh, vegetables, as well as
for gratinating, and for re-conditioning cooled and
frozen foods.
When placing food in the cooking compartment,
leave a space of at least 40 mm between pans in
order not to over-obstruct air circulation.
Do not use pans with higher than necessary edges:
edges are barriers which prevent the circulation of
hot air.
Warm up the oven before every cooking operation
to obtain maximum uniformity.
Do not salt foods in the cooking compartment.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 225165 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 225165 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 8,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info