625755

Gys STARTIUM 680E Manual

9
Zoom out
Zoom in
Previous page
1/28
Next page
9
STARTIUM 330E / 480E / 680E / 980E
EN
Charging multiple batteries simultaneously
You can charge multiple batteries simultaneously by connecting them in parallel. Connect the positive terminals to the
red clamp and the negative terminals to the black clamp. These batteries or group of batteries must all be the same
voltage, either 12 or 24V.
Charging in series is not recommended.
USE IN START MODE
Precautions before use
• Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information and a
possible inability to restart.
• The "START ENGINE" mode can detect sulphated batteries and in this event it will not start. The device will start an
automatic desulphation process prior to starting the battery to protect the vehicle electronics.
• If the battery is damaged, sulphated or too deeply discharged, starting is prevented in order to protect sensitive
vehicle electronic systems. In this event, the Startium shows intermittently “CIP” (Charge in Progress) and 0%. Battery’s
recovery is in progress.
Starting
Once the starter connected to the battery (see connection and disconnection) press key 13 to select the "START
ENGINE" mode. When this function is activated by pressing key 9, it will begin with a precharge.
STARTIUM 330E 50 - 80 Ah / 60Ah Instantaneous 5 min precharge
STARTIUM 480E 50 - 160 Ah / 100Ah Instantaneous 5 min precharge
STARTIUM 680E 50 - 220 Ah / 160Ah Instantaneous 5 min precharge
STARTIUM 980E 50 - 250 Ah / 220Ah Instantaneous 5 min precharge
By turning the key you activate the starter function.
If your engine does not start, wait 2 minutes between two start attempts. The attempt must last a maximum of 5
seconds.
Nb: A vehicle that will not start can be a problem other than a battery in poor condition. It could come from many other
causes.
After use follow the recommended instructions for disconnection.
TESTING THE ALTERNATOR
A test function of the alternator is available using key 12. It will indicate the charge capacity of the alternator by
displaying the voltage and the percentage.
Between 0 and 100% = The battery is not charged enough.
At 100% = Alternator ok.
Between 100% and 200% = Overcharge.
PROTECTION
This device has been designed with comprehensive protection functions:
• The charging clamps are fully insulated.
• A fuse provides proctection against reverse polarity and short circuits. The replacement request manual intervention.
STARTIUM 330E STARTIUM 480E / 680E STARTIUM 980E
FUSE
100A
FUSE
200A
FUSE
250A
• Thermal protection is provided by a thermostat (cooling time around 1/4h). The fault LED lights up in case of
overheating, the screen displays "TH".
• This device is equipped with a thermal proctection which will stop the power supply in case of over-heating. Allow 15
minutes for the unit to cool-down and place it in a well ventilated room.
• In case of a power supply problem, the device will stop, the fault LED only will ash and the screen will display "DEF".
If the problem is excessive an internal fuse protects the device. This fuse must be replaced by a qualied technician.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys STARTIUM 680E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys STARTIUM 680E in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info