625755
10
Zoom out
Zoom in
Previous page
1/28
Next page
10
STARTIUM 330E / 480E / 680E / 980E
EN
WARNING
WARNING! Explosive gas , avoid ames and sparks . During charging, the battery should be placed in a ventilated
area.
• Protect the unit from rain and moisture
If the power cable is damaged it must be replaced by the manufacturer , its after sales department or a similarly
qualied person to avoid hazard.
• The external fuse can be replaced and the circuit breaker can be engaged by the user.
• Under no circumstances should this appliance should be used to charge accumulators or non rechargeable batteries.
• Respect the connection sequence indicated .
• Product subject to separate collection , do not dispose in domestic waste .
This appliance is not intended for use by persons (including children) with reduced physical , sensory or mental
capabilities, or lack of experience or knowledge, unless they are supported by a person responsible for their safety,
supervision or instruction concerning use of the appliance.
• Children should not play with the device.
• Do not open the device. Modications not performed by the manufacturer's technician will void the warranty .
• Check that the available input voltage corresponds to the one indicated on the nameplate of the charger.
TROUBLESHOOTING
Troubleshooting Causes Remedies
Error LED ashed Power supply issue. Check the power supply.
Error LED ashes and alarm beep
Clamps in short-circuit or polarity
reversal.
Check if the fuses have blown
Do not put the clamps in short-circuit.
Reverse the polarity.
The battery is faulty.
Check the voltage at the battery
terminals with a voltmeter. If the
voltage instantaneously increase
by more than 2.5V by element the
battery can be sulphated or damaged.
Voltage error (12 -24 V)
Check the battery is connected on 12
or 24V.
Battery not detected or <1V. Display :
«BAt HS»
Connect the battery.
Select TIMER if the battery voltage is
<1V.
After an intensive use the device goes
to thermal protection. Display : «th»
Wait 1/4h for the device to cool
down.
The LEDs won't light up
Power supply issue. Check the power supply.
The internal fuse has blown
Return the device back to GYS after-
sales.
The On/Off switch isn't engaged. Switch the ON/OFF button.
In START ENGINE mode, if the screen
displays 0%. Restart impossible
The battery is sulphated, starting the
battery is prevented to protect the
vehicle electronics.
Recharge the battery prior using
START ENGINE.
The electrolyte is boiling
The voltage selected isn't correct
(12V or 24V).
Check the battery voltage and
connect it correctly.
The battery has an element in short-
circuit.
The battery cannot be recovered, it
must be replaced.
Clamp sparks
Polarity reversal
Connect the clamps correctly (+/+;-
/-)
Timer mode active See connection and disconnection
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gys STARTIUM 680E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gys STARTIUM 680E in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info