633026
8
Zoom out
Zoom in
Previous page
1/16
Next page
8
5.0 - DESCRIPTION OF THE ALARM SYSTEM ARMING/DISARMING
COMMAND WIRES
6.0 - DOORS LOCK/UNLOCK SIGNALS SELF-CODING
A - Using the RED/BROWN and RED/GREY wires you can arm and disarm the alarm
using the original vehicle remote, or door key lock.
- RED/BROWN WIRE: Connect to the vehicle wire that changes state when locking the doors.
- RED/GREY WIRE: Connect to the vehicle wire that changes state when unlocking the
doors.
Note: with this connection the YELLOW/BROWN and YELLOW/GREY wires have to be
connected to O/E vehicle earth.
B - Using the RED/BROWN, RED/GREY, YELLOW/BROWN and YELLOW/GREY wires,
the alarm will only arm and disarm using the original vehicle remote. YELLOW/BROWN
and YELLOW/GREY wire connections can be found in the vehicle technical guides
supplied by GT.
- YELLOW/BROWN WIRE: This wire has to be connected to the vehicle’s locking wire which
is only present when the door lock is being operated by the original vehicle remote.
- YELLOW/GREY WIRE: This wire has to be connected to the vehicle’s unlocking wire which
is only present when the door lock is being operated by the original vehicle remote.
WARNING:
- Ensure that the RED/BROWN, the YELLOW/BROWN, the RED/GREY and the YELLOW/
GREY wires are correctly connected (as indicated in the GT vehicle installation guides
or following the DESCRIPTION OF THE ALARM SYSTEM ARMING/DISARMING
COMMAND WIRES section), the ignition key must be in off and the alarm disarmed.
1- Earth the GREEN/YELLOW wire until the alarm system will emit a long acoustic signal and
the LED BUTTON starts to flash.
2 - During the next 10 seconds disconnect and then reconnect the earth to the GREEN/
YELLOW wire.
Note: after 10 seconds the alarm system will emit 3 visual (indicators)/acoustic signals and
automatically start the RAPID TEST procedure.
3 - At this point the system will emit 6 visual (indicators) /acoustic signals to indicate that it is
in condition to SELF-CODE THE DOORS LOCK (arming) AND UNLOCK (disarming)
SIGNALS; when the LED BUTTON starts flashing you have 2 minutes to carry out the points
4, 5 and 6.
4 - Make sure that all the doors and the boot and bonnet closed.
5 - Lock the vehicle using the original remote control, after a couple of seconds the alarm will
emit 1 visual (indicators)/acoustic signal and the doors will lock.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for GT 800-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of GT 800-2 in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info