30117
8
Zoom out
Zoom in
Previous page
1/104
Next page
Operating Instructions
8 General Section
Frequency band and Channel change
Change frequency band
: The Transmitter can be
operated on different frequency bands by changing
the High Frequency module. The removable HF
module is held by four sprung pin fittings in the
centre of the Transmitter. Two cables must be
attached. Link 1 connects to the Transmitter circuit
board. Link 2 connects the HF module to the aerial.
Changes of the HF channels: The channel is
determined by the crystal. Only crystals of the
correct type and the appropriate frequency band may
be used (see page 98).
The Transmitter crystals “T” is put into the HF
module. Frequency band and channel number of the
crystal inserted must correspond with that in the
Receiver.
Installation the Module
The Transmitter case is pre-drilled for the installation
of the modules, like NAUTIC, Proportional and
Switch Module. The blanking caps in the holes of the
case can be removed pushing them outward with an
appropriate object. To complete the assembly of the
Proportional and Switch modules, Part. No. 4152 or
4151, they must be connected to the HF module.
The NAUTIC modules are installed by inserting the
controls through the pre-drilled holes in the case
(from the inside) (see next paragraph "fastening the
modules"). Ensure that the connection socket of
these modules points to the centre of the transmitter.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MC16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MC16 in the language / languages: English as an attachment in your email.

The manual is 16,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MC16

Graupner MC16 User Manual - German - 68 pages

Graupner MC16 User Manual - French - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info