30117
9
Zoom out
Zoom in
Previous page
1/104
Next page
General Section 9
Fasten the NAUTIC modules
Insert the module into the intended location and that
check it fits correctly. The protective plastic film on
the printed fascia plate can be now taken off. Then
remove the backing paper of the double sided tape
and the attach the fascia plate lightly pressing it
down. Insert the module from the inside into the
prepared module location. The module is secured by
fitting the washers and nuts to the potentiometers or
switches and carefully tightening them with a suitable
tool. Finally, mount the control knobs to the
potentiometers so they correspond with the scale
markings.
Length adjustment of the control sticks
The length of the control sticks can be adjusted up to
the maximum length marking on the stick shaft.
INC/DEC Keys
By installation of a 2 way momentary switch, Part.
No. 4160.44, the functions of the INC / DEC keys
can be taken over. The connection is made to the
sockets marked INC and DEC on the transmitter
circuit board, see page 10.
The switch increases the operating ease, especially
when model-specific values are programmed during
operation.
Assembly of the Transmitter Carriers
The transmitter can be equipped with the transmitter
mounting Part. No. 1127. Open the transmitter case
and in remove the bottom blanking caps. The bottom
of the case is already prepared for the assembly.
The four mounting plate holes in the bottom of the
case can be opened up by boring through using a
screwdriver. From inside the case, insert the metal
arms through the mounting holes. The plastic
mounting plates are fed over the metal arms and
screwed to the outside of the case, with two screws
each. The carrier arms are strongly retained up a
long coil spring. If softer folding of the carrier arms is
required, the spring must be shortened accordingly.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Graupner MC16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Graupner MC16 in the language / languages: English as an attachment in your email.

The manual is 16,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Graupner MC16

Graupner MC16 User Manual - German - 68 pages

Graupner MC16 User Manual - French - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info