590611
7
Zoom out
Zoom in
Previous page
1/28
Next page
GMC-I Messtechnik GmbH 7
2 Initial Start-Up
Installing Batteries
Attention!
!
Disconnect the instrument from the measuring circuit at all poles before
opening the battery compartment!
Fold the instrument closed.
Insert a coin or a similar object into the slot between the housing and the
battery compartment cover and press down until the battery compartment
cover snaps open.
Fold the instrument open as far as it will go and remove the battery
compartment cover.
Insert two 1.5 V mignon batteries per IEC R6 or IEC LR6 into the battery
compartment, making sure they are poled in accordance with the symbols.
Replace the battery compartment cover and press into position until it
audibly snaps into place.
Switching the Instrument On
Set the toggle switch to the “ON” position.
Activation of the instrument is acknowledged with an acoustic signal.
If the instrument has been shut down automatically, press either the FUNC, DATA or
MAN key to switch the multimeter back on, or set the toggle switch to the “OFF”
position and leave it there for at least 5 s before returning it to the “ON” position.
Note!
Electrical discharges and high frequency interference may lead to erro-
neous display values, and may disable the measuring sequence. Reset
the instrument by switching it off and then, after 5 s, back on again.
Switching the Instrument Off Manually
Set the toggle switch to the “OFF” position and fold the instrument closed. The
battery is automatically disconnected when the multimeter is folded closed.
Automatic Shutdown (standby)
The instrument switches itself off automatically if the measured value remains
constant for a long period of time (maximum measured value fluctuation approx.
0.8% of the measuring range per minute, or 1 Celsius or 1 Fahrenheit per min-
ute), and if no keys are activated for a period of approximately 10 minutes. Shut-
down is acknowledged by a brief acoustic signal. Exception: continuous opera-
tion mode.
Note!
Electrical power is supplied to the processor even after the instrument
has been switched off automatically. A closed-circuit current of about
200 A remains. The instrument is only disconnected from the batteries
after it has been switched off manually with the toggle switch or with the
instrument folded.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gossen Metrawatt METRAport 40S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gossen Metrawatt METRAport 40S in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info