725140

Gloria Multibrush SpeedControl Manual

28
Zoom out
Zoom in
Previous page
1/56
Next page
28
GB
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
! Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!
6.1.4 Using the surface brush
on wood surfaces (optionally
available as an accessory)
ATTENTION! Improper use of the
device poses a risk of damage to
property! You should therefore
observe the following safety
instructions:
! Never use the hard surface brush
with the black bristles for cleaning
wood surfaces, as the hard bristles
attack the surface of the wood,
thereby damaging it.
NOTE!
! For cleaning wood surfaces use the
soft surface brush with the yellow /
black bristles.
This is available as a GLORIA accesso-
ry and is not in cluded in the scope of
delivery.
! Assembly and operating instructions
can be found in the product informa-
tion “Surface brush for wood
surfaces”.
6.1.5 Using and replacing the
joint brush
Figures 22 - 24
Assemble the joint brush as described
in Chapter 6.1.2. Place the device
parallel with guiding wheel and joint
brush on the joint to be treated. Hold
the device at working angle and make
sure that the rubber lip on the safety
guard (H) is just above the ground.
NOTE!
To adjust the safety guard (H), turn the
7 click-stop safety guard to the posi-
tion described under point “22”.
Align the joint brush with the centre of
the joint, walk at an even steady pace and
push the device in front of you. Adapt
your pace of work to the degree of soiling.
NOTE!
! Always work along the joint and hold
the device away from your body.
! In cases of stubborn dirt you can
move the device backwards and
forwards on the spot (like a scrubber),
until the required result is achieved.
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
! Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!
6.2 User information
! Do not remove any wet weeds with
the device.
! Never clean wood decks or wood
terraces with the joint brush.
! Only clean joints that are intact.
Damaged or crumbling joints or joints
with cracks should not be cleaned
with the device.
! Rinse the cleaned surfaces thoroughly
after cleaning.
! Worn brushes i.e. frayed bristles
should be replaced in good time.
! Switch off the device, before starting
with the next cleaning course (e.g.
wood decks).
6.3 Replacing the joint brush
Figures 25 - 29
!
Switch off the device and disconnect the
power cord (C) from the power supply.
22
23
24
RZ_MULTIBRUSH_DE_GB_FR_NL_978410-1_Text_GB 10.11.16 15:55 Seite 28
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gloria Multibrush SpeedControl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gloria Multibrush SpeedControl in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info