583758

Garmin GPSMAP 2110 Manual

26
Zoom out
Zoom in
Previous page
1/106
Next page
18 GPSMAP 2106/2110 Owner’s Manual
BASIC OPERATION > REVIEWING AND EDITING WAYPOINTS
To delete a single waypoint from the User sub tab:
1. Use the ROCKER to highlight the waypoint you want to delete, and then
press the Delete Waypoint soft key. A confirmation message appears.
2. Highlight OK, and press ENTER to delete the selected waypoint.
To delete waypoints by symbol:
1. On the User sub tab, highlight the waypoint you want to delete.
2. Press the Delete By Symbol soft key.
3. Use the ROCKER to highlight the symbol of the waypoints you want to
delete, and press ENTER.
4. Highlight OK, and press ENTER to delete the waypoints by symbol.
Otherwise, highlight Cancel, and press ENTER to return to the User sub
tab without deleting any waypoints.
To delete all user waypoints:
1. On the User sub tab, press the Delete All soft key.
2. Highlight OK, and press ENTER to delete all user waypoints.
Proximity Waypoints
Use the Proximity sub tab to define an alarm circle around a stored waypoint. The
alarm circle can help you avoid reefs, rocks, or restricted waters. You can add
proximity alarms to a maximum of 10 waypoints or on-screen map items, with a
maximum alarm radius of 99.99 nautical or statute miles, or kilometers.
If a proximity alarm circle overlaps an existing alarm circle, the message
“Proximity Overlaps Another Proximity Waypoint” appears. Because the unit
only alerts for one of the overlap points, use caution when navigating in these
areas. If your boat enters a red proximity circle overlap, you are alerted only to
the closest proximity waypoint.
Proximity circle Proximity waypoint
… 26 …


Need help? Post your question in this forum.

Forumrules
1

Forum

garmin-gpsmap-2110

Reset search

  • I have acquired a Garmin 2110 with a GPS17.
    The cable between the two has been carefully cut - I assume to remove it from the previous vessel. I have connected all the cables together as per the Basic Installation shown in the handbook. All works fine.
    My question is how can i reconnect the two (front and rear) looms together. The wires from the GPS17 are too fine to solder and not of sufficient size as to allow connection by electrical Mobloc.
    Can anyone help me by telling me what they have used to connect these looms together?
    Thanks in anticipation
    Ian Hutchinson Submitted on 15-4-2021 at 11:46

    Reply Report abuse

  • I have just acquired a Garmin 2110 and GPS17.
    The wires that connect the two together have been carefully cut - I assume to enable the units to be removed from the previous vessel. I have connected all the wiring together as per the Basic Wiring diagram and all worked perfectly.
    However the wires from the GPS17 are extreamly delicate and will not (maybe my inexperience ) allow solder connections in order to make the installation complete. My question is what can I use to make a permanent fixing of the two (front and rear) looms?
    I have tried using a small mobloc but the wires in the GPS17 loom are too fine to make a good connection.
    Any help would be greatly appreciated
    Ian Hutchinson Submitted on 15-4-2021 at 11:25

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin GPSMAP 2110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin GPSMAP 2110 in the language / languages: English as an attachment in your email.

The manual is 6,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info