522211
10
Zoom out
Zoom in
Previous page
1/32
Next page
6 Fishfinder 160C Owner’s Manual
INSTALLATION INSTRUCTIONS > TRANSDUCER INSTALLATION
Mounting the Transducer on a Trolling Motor
To mount the transducer on a trolling motor:
1. Slide the large cable tie through the slot on the transducer
mount with the ridges of the band facing up until equal
lengths extend on both sides of the mount. (NOTE: For cold
water, or heavy timber or debris areas, a metal 4-5" worm
gear clamp is recommended.)
2. Position the mount gasket on the curved top of the transducer
mount.
3. Place the transducer assembly against the motor body of the
trolling motor, with the front of the transducer pointed away
from the trolling motor propeller.
4. Wrap the two ends of the cable tie around the motor body.
Place the pointed end of the cable tie through the fastener
hole on the opposite end and pull it through until it is snug but
not tight. (The cable tie clicks when you pull it.)
5. Position the transducer so that it is parallel with the bottom
when in use, and make sure the gasket is aligned properly.
Pull the cable tie end until tight. Trim off the excess, if
necessary. Tighten the 10-32 locking nut until it touches the
mounting bracket and then tighten 1/4 turn more. (Do not
overtighten.)
6. Route the 30' (9 m) transducer cable using the supplied cable
ties to secure the cable to the motor shaft. You can fill the
forward-facing portion (except the cable tie pocket) of the
transducer mount with sealant to avoid accumulating debris.
Cable tie
Mounting
gasket
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Fishfinder160C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Fishfinder160C in the language / languages: English as an attachment in your email.

The manual is 2,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info