522211
12
Zoom out
Zoom in
Previous page
1/32
Next page
8 Fishfinder 160C Owner’s Manual
INSTALLATION INSTRUCTIONS > WIRING HARNESS INSTALLATION
Wiring Harness Installation
The Fishfinder 160C comes with a wiring harness that connects
the unit to power and the transducer with one easy-to-remove
connection. If it is necessary to extend the power wires, use 22
AWG wire. DO NOT cut the transducer cable, as this will void
your warranty. Transducer extension cables are available from your
Garmin Dealer.
If your boat has an electrical system, it may be possible to wire the
unit directly to an unused holder on your current fuse block. If you
are using the boat’s fuse block, remove the in-line fuse supplied with
the unit. You may also wire the unit direct to the battery.
To install the wiring harness:
1. Install the Red (+) wire on the positive battery terminal.
2. Install the Black (-) wire on the negative battery terminal.
3. Install a 2 Amp fuse in the fuse holder (fuse block only).
4. Align the notches on the cable plug and back of the unit.
Insert the cable into the connector and turn the lock ring
counter-clockwise until it stops.
The FF160C outputs NMEA data for: Water Depth, Water Speed and
Water Temperature.
To connect the NMEA output to a NMEA device:
Connect the Blue wire to the Data Input of the NMEA device.
(red) + 10-18 VDC
(black) - Ground (Power/Data)
(blue) Port 1 Data OUT
(yellow) Alarm Low
GPS/NMEA
Device
10-18 volts
DC
Power
RXD +
TXD +
Alarm Relay
100ma max
coil current
To Transducer
To Unit
Wiring Diagram
2A
-
+
Red +
Wiring to a Fuse Block
Black -
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Garmin Fishfinder160C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Garmin Fishfinder160C in the language / languages: English as an attachment in your email.

The manual is 2,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info