724657

Gardenline YR-HT250 Manual

11
Zoom out
Zoom in
Previous page
1/19
Next page
25cc 4 Stroke Petrol Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. YR-HT250 • 10/2017 • 52742
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. YR-HT250 • 10/2017 • 52742
25cc 4 Stroke Petrol Hedge Trimmer
18 19
Warm Start
(Engine has been stopped for no more than 15-20 minutes)
When restarting the hedge trimmer after it has been used and the engine is
hot, there is no need to engage the choke lever (red) (20). Follow steps 6-9
as detailed in previous section.
A Flooded Engine
If the choke lever (red) (20) has been left in the full choke position and the
engine will not start, it is possible the engine has been ooded (too much
fuel).
To assist to clear a ooded engine:
1. Move the choke lever (red) (20) to the
run position.
2. Squeeze the safety lever (12), and pull on the
throttle trigger (11) (Fig O).
3. Check the on/o switch (10) is in the downward
ON position as indicated with an “I” (Fig I).
4. Pull the recoil starter (9) a number of times to
clear the fuel and start the motor. A smooth rapid pull is required for a
strong spark.
WARNING. Be aware that if starting occurs with the throttle trigger (11)
pressed in the down position, the motor will accelerate thus engaging
the clutch, which will then operate the oscillating blades.
As soon as the motor starts, release the throttle trigger (11) so the motor
runs at idle speed and disengages the clutch.
Stopping the Engine
Emergency Stopping Procedure
When it is completely necessary to stop the engine immediately, press the
“O” symbol on the on/o switch (10) to the OFF position until the
engine stops.
Normal Stopping Method
For normal stopping, release the throttle trigger
(11) (Fig P) and allow the engine to return to its
idle speed. Press the “O” symbol on the on/o
switch (10) to the OFF position until the
engine stops.
Running in the engine
1. During the rst 2–3 hours of work, run the
engine at a moderate RPM.
2. We advise you in any case not to maintain your engine at a high speed
as the dierent components must settle with each other during the
process of running in the engine.
3. It is at the end of the running in period that the engine will reach its
maximum power.
4. After the rst two hours of work, stop and make sure that all nuts and
screws are securely fastened, and tighten them if necessary.
Operation of the Throttle Trigger – Adjusting the speed
The operation of the hedge trimmer is fully controlled from the rear
rotating handle (13).
The throttle trigger (11) fully controls the hedge trimmer as follows.
1. With the engine running and the throttle trigger (11) not being
pressed, the speed of the motor is at idle and at idle, the blades are NOT
engaged. Do not continue to run the hedge trimmer if while in the idle
position the blades are operating.
Every time the hedge trimmer is started, always test to ensure the clutch
engages under acceleration and then at idle the blades are
NOT engaged.
2. To engage the blades (1), the engine needs to
accelerate.
To increase the speed of the engine, press the
safety lever (12) down rst, and then squeeze
the throttle trigger (11) (Fig Q). The further you
squeeze the throttle trigger (11), the faster the
engine will run. During the increase in engine
speed, the blades (1) will engage.
O.
P.
Q.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline YR-HT250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline YR-HT250 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info