724657

Gardenline YR-HT250 Manual

10
Zoom out
Zoom in
Previous page
1/19
Next page
25cc 4 Stroke Petrol Hedge Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. YR-HT250 • 10/2017 • 52742
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. YR-HT250 • 10/2017 • 52742
25cc 4 Stroke Petrol Hedge Trimmer
16 17
7. Pull the recoil starter (9) lightly until you feel
resistance then pull quickly until the engine
starts (Fig M) (Under full choke it may only
run for 1 or 2 seconds). A smooth rapid pull is
required for a strong spark. Do not pull the cord
with a jerk or release it until fully rewound.
8. Once the engine starts allow to run for 10
seconds.
NOTE: If the engine starts and then stops, even
for 1 sec, move the choke lever (red) (20) to the
mid way position between the full choke and no
choke position and pull the recoil starter (9) to
restart.
WARNING: On start up the oscillating blades
may be operational due to the setting of the
starting throttle. Be well aware of this condition
9. Once the engine is fully warm ensure the choke
lever (red) (20) is down fully to the run position.
(warm start) (Fig N).
10. If the engine fails to start, repeat steps 1
through 9.
NOTE: If the engine fails to start after repeated
attempts, refer to Troubleshooting section.
NOTE: Always pull the recoil starter (9) straight
out. Pulling the recoil starter (9) at an angle will
cause it to rub against the eyelet. This friction
will cause the cord to fray and wear more
quickly. Do not pull the end of the cord, this can
damage the recoil starter (9). Always hold the
recoil starter (9) handle when the cord retracts.
Never allow the cord to snap back from the
extended position. This could cause the cord to
snag or fray and also damage the recoil starter
(9) assembly.
1. Place the hedge trimmer upright on a rm at surface
2. Move the on/o switch (10) to the ON position by pressing the section
of the switch marked with an “I” (Fig H).
3. This hedge trimmer has a 2 position choke: Full Choke and No Choke.
Start position (choke closed / full choke)
Run position (choke open / no choke)
4. Move the choke lever (red) (20) towards the front of the hedge trimmer
(towards the blades) to the full choke or cold start position (Fig I). This
direction also indicated on the housing (Fig J).
NOTE. This is not required if the engine is already warm.
5. Push the primer bulb (19) 6-10 times, until the primer bulb is rm to
press, or until there are no air bubbles visible in the fuel discharge line
(Fig K/L).
NOTE: When the carburettor has sucient fuel for starting, the excess
fuel as you pump the primer bulb (19) is bypassed back into the fuel
tank (15) through the clear fuel line.
NOTE: The primer bulb (19) is located behind the left hand side of the
air lter cover (when viewing from the rear handle end of the unit) and
is located above where the clear and black fuel lines can be seen.
NOTE. For cold starting this is an important step.
6. Check the ignition on/o switch (10) is in the downward ON position as
indicated with an “I” (Fig H).
J.I.H.
K.
M.
N.
L.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gardenline YR-HT250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gardenline YR-HT250 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info