30098

Futaba FP8SSHP Manual

6
Zoom out
Zoom in
Previous page
1/36
Next page
14.
Aileron dual rate switch
Aileron dual rate ON-OFF switch. When set to the
pull position dual rate is turned on, and when
set to the push position, dual rate is turned off.
At dual ON, the deflection can be set as shown in
Fig. 7 with the (1) aileron dual rate trimmer locat-
ed on the trimmer panel at the back of the trans-
mitter. At dual OFF, the operating linearity
can be switched as shown in Fig. 8 with the (2)
LINEAR-VTR switch also located on the trimmer
panel.
Deflection is adjustable
from 40% to 100% of
the total travel within
this range.
Fig.
7
LINEAR side
15. Elevator dual rate switch
• Elevator dual
rate
ON-OFF switch
Similar to aileron dual rate, the elevator deflec-
tion can be adjusted with the elevator dual rate
trimmer
[23]
and LINEAR-VTR switching can be
performed with switch [24] Other functions are
the same as elevator dual rate.
•Aileron dual rate and elevator dual rate can be
switched ON and OFF simultaneously (combina-
tion ON-OFF) or separately by setting switch [25]
on the trimmer panel at the back of the transmit-
ter. In the simultaneous ON-OFF mode, aileron
dual rate and elevator dual rate are turned on and
off with the aileron dual rate switch [14]
16. Rudder dual rate switch
Rudder dual rate ON-OFF switch. Similar to
aileron dual rate, the rudder deflection can be
adjusted with the rudder dual rate trimmer [20] and
LINEAR-VTR switching can be performed with
switch [21] . Other functions are the same as aileron
dual rate.
17. Revolution mixing up side ratcheted
knob (UP knob)
18. Revolution mixing down side ratchet-
ed knob
(DOWN knob)
• These knobs vary the pitch control — rudder mix-
ing amount from 0 to 70% of the total travel at
the up and down sides. This mixing is performed
when the hovering memory switch [36] on the
back of the transmitter is set to ON, when switch
[36]
is set to OFF, mixing is not performed even if
knobs [17] and
[18]
are turned. The UP knob [17]
adjusts the high side mixing amount from the
memorized throttle stick hovering position. The
DOWN knob [18] adjusts the low side mixing
amount from the memorized throttle stick hover-
ing position.
• Switch [22] on the trimmer panel changes the mix-
ing direction and releases the mixing function.
•The mixing amount to the rudder (pitch
control
-> rudder) is controlled by adjusting the revolu-
tion
mixing compensation
with
trimmer [16]
in
Fig.
9.
Revolution mixing compensation
Rudder servo
4
Fig.
8
When this compensation is suitably applied, the
high speed linearity in the air is improved and
power loss is minimized.
FIG.
9
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP8SSHP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP8SSHP in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info