30094

Futaba FP8SSAP Manual

35
Zoom out
Zoom in
Previous page
1/44
Next page
ADJUSTMENTS AND FLIGHT TECHNIQUES
EXAMPLE 1. Pig. 58. AILERON -> RUDDER MIXING
• This function is sometimes referred to as"CAR" (Coupled Ailerons and Rudder) and is useful on sailplanes
and
certain scale models where aileron and rudder must be used together for coordinated turns.
1.Connector 14
designates
the
Master
channel
and is set vertically at the CH1 (Aileron) posi-
tion.
2. Connector 13 designates the Slave channel and
is set vertically at the CH4 (Rudder) position.
3. Set
Switch 30
to
P.
MIX if
it
is
desired
to
turn
the mix function ON and OFF in flight. Other-
wise, it will remain ON and Control Switch 16)
is available for use as the Rudder Dual Rate
ON/OFF Switch.
NOTE: If Switch 16 is used as the P. MIX ON/
OFF Switch, Rudder Dual Rate cannot be
switched manually, but Auto Dual Rate Rudder
can still be used.
4.
Use Trimmers 11 and 12 to set the amount
and direction of desired Rudder movement
when the Aileron stick is deflected.
Fig.
58
EXAMPLE 2. Fig. 59.
•Programmed Mixing can be used to correct an
unwanted UP or DOWN pitch movement of the
aircraft when Rudder is during knife edge and
rolling maneuvers.
1.Set the Mixing Board as shown in Fig. 59 to
provide mixing from Rudder ->
>
Elevator.
2. Use Trimmers [11] and [12] to adjust the desired
amount and direction of Elevator compensation
when Rudder is applied in both Left and Right
directions.
EXAMPLE3.Fig.60.
Fig. 59
33
• Certain aircraft such as scale models with large
dihedral or stunt aircraft with incorrect dihedral
may exhibit an unwanted rolling tendency when
Rudder is applied (as opposed to a pure Yaw
motion).
This can
cause
variations
in the roll
rate
during slow rolls and/or a "roll out" tendency
during point rolls and knife edge maneuvers.
This can be corrected with Programmed Mixing.
1. Set the mixing panel as in Fig. 60 to provide
mixing from Rudder to Aileron.
2.Trimmers 11 and 12 can be adjusted so that a
small amount of corrective Aileron is automati-
cally applied with Rudder movement. Both
directions of Rudder movement can be adjusted
for.
EXAMPLE 4.
•An unwanted Left or Right Yaw tendency during pull ups can be adjusted by setting the mixing panel
for Elevator to Rudder mixing (Elevator CH2 is the Master channel).
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP8SSAP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP8SSAP in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info