30094
32
Zoom out
Zoom in
Previous page
1/44
Next page
ADJUSTMENTS AND FLIGHT TECHNIQUES
•FLAP/ELEVATOR MIXING
(PRE-SET FLAPS AND ELEV. TRIM)
FLAP-> ELEVATOR MIXING (ELEVATOR DOWN MIXING) ADJUSTMENT
• This is a pre-set or switch-activated type of mix-
ing and is ideal for landing approaches with
stunt and scale aircraft. An airbrake effect is
produced which is very realistic and makes short
field landings easier.
H
19
32
20
N
Fig.
49
1. Set Airbrake Switch [32] (6, 7 -> 2 MIX) to ON.
Monitor Lamp (C) comes ON. Control Switch
10 can be used to turn the function ON and
OFF
in flight. When
Switch 10 is ON, Lamp
(C) Blinks.
2.Turn
Switch 10 ON
and
set
Flap
Knob 6
to
Zero. Lower the flaps 45 to 60 degrees using
Trimmer [20] and set the Elevators about 3
degrees down using Trimmer 19. NOTE: These
settings are estimates and will vary depending
on elevator and flap areas, etc.
3.Set
Switch 10
to
OFF for takeoff.
When
at
a
safe altitude, reduce the throttle to medium
slow and after the aircraft has slowed some-
what, turn Switch 10 to ON. The aircraft
should maintain level flight. If the aircraft
climbs or dives, set Switch 10 to OFF, land,
and readjust the elevator angle as necessary
with Trimmer 19 . Remember, do NOT try to
adjust back panel trimmers while in Flight.
Make adjustments in small steps.
4. Flap Neutral position can be changed in Flight
using the Flap Knob 6 . This applies whether
mixing in ON or OFF.
30
Fig.
50
•AIRCRAFT WITH FLAPS AND SPOILERS
(AIRBRAKE)
Fig.
51
1. Connect the Flap servo to CH6 and the Spoiler
servo
to CH7 on the Receiver. Set Switch
[32]
to
ON.
2. Set Control Switch 10 to ON and adjust the
flaps as shown in Fig. 51 with Trimmer [20].
Adjust the spoiler servo travel with Memory
ATV Trimmers [46] and 47. (See Page 17)
3.When
used
in
this
manner,
flaps
and
spoilers
will
be
deployed
simultaneously
to
the
pre-set
positions when Switch 10 is set to ON. This
acts as an airbrake. NOTE: In this mode, the
Spoiler Knob 7 will be inoperative and its
function transfered to Switch 10 . Alternative-
ly, Switch [32] can be set to CH7 OFF and Knob
7 used for spoiler control.
4. Elevator Trimmer 19 can be adjusted if neces-
sary
so
that the
aircraft
maintains
level
flight
with the airbrake deployed.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba FP8SSAP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba FP8SSAP in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info