747924
14
Zoom out
Zoom in
Previous page
1/23
Next page
14
Each transmitter has an individually assigned, unique ID code. In order to start operation,
the receiver must be linked with the ID code of the transmitter with which it is being paired.
Once the link is made, the ID code is stored in the receiver (T-FHSS; and transmitter) and no
further linking is necessary unless the receiver needs to be used with another transmitter. (For
T/R set, the link is already done at factory.)
Link procedure S-FHSS/FHSS (R203GF)
1
Bring the transmitter and the receiver close to
each other, within 20 inches (half meter).
2
Turn on the transmitter and the receiver.
3
Push and hold the Link Switch of the receiver.
4
When the link is complete, the LED in the receiver changes to solid green.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception LED : OFF
Receiving signals LED: Green ON
Receiving signals, but ID is unmatched LED: Green Blink
Link procedure T-FHSS (R304SB/R314SB)
1
Bring the transmitter and the receiver close to
each other, within 20 inches (half meter).
2
Turn on the transmitter.
3
Select [LINK] and access the setup screen
shown below by pressing the select key [
].
Next, press and hold [
] or [
] key.
4
Turn on the receiver.
5
During countdown, push and hold the receiver tact switch. The LED will begin to blink
red. After the receiver LED switches from blinking red and green
red steady light,
release the tact switch of the receiver. If the receiver LED lights green, linking was
successful. Also check servo operation.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception Red : On
Receiving signals Green: On
Unrecoverable failure (EEPROM,etc.) LED: Red and Green turn on alternately
Link Switch
LED
How to Link
ڦLink Mode
Press and hold or
key.
Link mode for 20
seconds.
Blink with Link mode
+ or - Press and hold
Link SwitchLED
*Link is required when a new model
is made from a model selection.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Futaba 3PV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Futaba 3PV in the language / languages: English as an attachment in your email.

The manual is 1,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info