Ferm 13
Toppling:
• Slacken the locking screw (25).
• Topple the table (5) to the required position.
• Tighten the locking screw.
Adjusting the table extenders
Fig. F
Using the table extenders you can support long workpieces.
• Slacken the wing nuts (26).
• Slide the extender (27) outward.
• Tighten the wing nut.
Adjusting the speed
Fig. G
• Remove the screw (28) and open the cover (29).
• Slacken the screws (30) and push the motor housing (2) to the front to release the tension
on the V-belt (31).
• Put the V-belt in line on the pulleys (32) in one of the combinations specified on the inside of
the cover.
• Push the motor housing to the rear to tension the V-belt.
• Clamp the motor housing in position by tighening the screws (30).
• Close the cover and re-fit the screw (28).
Switch off the machine and wait until the machine has come to a complete standstill
before changing the speed.
Adjust the speed to the material to be drilled and the drilling diameter:
• For drilling in wood, choose a high speed.
• For drilling in metal and plastics, choose a lower speed as the drilling diameter increases.
Instructions for use
• Use waste material to practise your skills and to learn operating the machine first.
• When drilling through, adjust the table to make sure that the drill is alligned with the opening
in the centre of the table. If required, mark the position on the front side of pillar and table in
case the table should be set in the same position at a later time.
• Securely tighten the workpiece. Toppling, turning or sliding not only results in a rough
drilling hole, it also increases the risk of the drill breaking off.
• Use a piece of waste wood as a backup to reduce the risk of the workpiece splintering and
to protect the drill tip.
• Place flat workpieces on a wooden underground and clamp securely to the table to prevent
them from turning. Support workpieces that are irregular of shape and cannot be put flat
onto the table.
• Use the lift handles to bring the drill lift downwards. Slowly feed the dril into the workpiece.
• Drill slowly when the drill is about to break through the workpiece to prevent splintering.
GB
D
NL
F
E
P
I
S
FIN
N
DK
92 Ferm
Defekte og/eller kasserte elektriske eller elektroniske apparater må avhendes ved
egnete returpunkter.
Garanti
Se det separate garantikortet for garantivilkårene.
CE ERKLÆRING AV ANSVARSFORHOLD (N)
Vi erklærer at det er under várt ansvar at dette produkt er i overenstemmelse med følgende
standarder eller standard-dokumenter:
EN61029-1, EN60825-1, EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3
i samsvar med reguleringer:
98/37/EC, 73/23/EEC, 89/336/EEC, 2002/95/EC, 2002/96/EC
frà 01-09-2006
ZWOLLE NL
J.A. Bakker - van Ingen J. Lodewijk
CEO Ferm BV Quality Manager Ferm Global
Det er vår policy å stadig forbedre våre produkter, og derfor forbeholder vi oss retten til å
forandre produktspesifikasjonene uten forutgående varsel.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Nederland
GB
D
NL
F
E
P
I
S
FIN
N
DK
