Caution: You must tighten both knob nuts very rmly to ensure that the U-shaped bracket is ush against the U-shaped bracket
mount.
Figure 6: Knob nut lockFigure 7: Assembly of frame holder
Result:
Assembly of frame holder
Open the knob nuts of the frame holder by rotating the key by 180°
clockwise (Figure 6). Hold the claw for the bicycle rack together rmly
in one hand. Rotate the knob nuts of the frame holder anti-clockwise
until the locking mechanism of the clip is extended suciently that the
clip can be opened. Open the clip and place it around the shaft of the
U-shaped bracket. Close the clip and push the locking mechanism down.
Rotate the knob nut clockwise to such an extent that the clip can no
longer be opened.
Remove the screws from the lamp mount before installing the license plate holder and then mount the license plate holder. The license plate holder must be at
the same height as the lights.
The mounting clips (17) for securing the license plate are push-out parts in the holder.
Break out two of the clips. Slide the license plate into the holder, then push the clips into the
cut-outs (18) to secure the license plate.
Insert the short tensioning strap from the inside to the outside below the bike holder and
then from the outside to the inside through the slots of the bike holder (Figure 11). For the
rear wheel of the bicycle, use the centre slot of the wheel holder, for the front wheel, use the
two outer slots (two tensioning straps to prevent the front wheel from turning).
Secure the cables of the lights to the underside of the rack using the supplied cable ties (15). Make sure that the cables cannot be damaged when lowering and
raising the rack.
Laying electrical cables
Attaching the wheel rail covers
Figure 12: Wheel rail cover
Figure 13: Result of Step 3
Result:
Fit the wheel rail covers (16) to the rail stoppers (Figure 12).
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Eufab 11565 - Amber Plus at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Eufab 11565 - Amber Plus in the language / languages: English, German, French, Italian as an attachment in your email.
The manual is 2.91 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
