815612
56
Zoom out
Zoom in
Previous page
1/352
Next page
User manual
56
EN
Reset alarms
Allows to unblock a heat pump blocked and switched to emergency mode by the
repetition of a critical alarm.
Allows to cancel a recurring alarm condition produced by the repetition of the same
alarm.
4. Troubleshooting
4.1. Comfort deficiencies
In the event of lack of comfort in any of the services, use the following table to identify the most common problems that users can
solve on their own.
Symptom
Possible cause
Remedy
Where
The compressor does not start up
No power supply.
Check the circuit breaker.
External
cabinet
The heat pump is switched off. The main screen
shows .
Switch the heat pump on.
Block due to repeated alarms. red light stays on.
The main screen shows .
Deactivate the alarm block.
Heat pump time schedule activated. The main
screen shows .
Adjust or deactivate the time schedule of
the heat pump.
The main screen shows STAND-BY.
No service demands. Check whether there
are any active demands.
Active wait for compressor start-up. The main
screen shows xx.
Wait until the time by xx passes.
Active EVU signal. The main screen shows .
Wait until the EVU signal is deactivated.
Low DHW temperature
Active DHW time schedule.
Adjust or deactivate the DHW time
schedule.
Night-time programming activated. The main screen
shows .
Adjust or deactivate the night-time
program.
DHW mode deactivated.
Activate the DHW mode.
DHW mode deactivated by remote control.
Deactivate DHW remote control.
DHW temperature is between the setpoint and the
differential.
Increase the setpoint temperature and/or
reduce the start-up differential
temperature
High momentary demand.
Wait 15 - 30 minutes and check DHW
temperature again.
Indoor room temperature:
low in HEATING mode
high in COOLING mode
Incorrect operation program.
Select the appropriate program.
HEATING / COOLING mode deactivated.
Activate the HEATING / COOLING mode.
Outdoor temperature high / lower than the heating
/ active cooling / passive cooling cut-off
temperature.
Adjust the heating / active cooling /
passive cooling cut-off temperature.
HEATING / COOLING time schedule activated.
Adjust or deactivate the HEATING /
COOLING time schedule.
Reset alarms
Reset alarms:
/8
On/Off
Unit address:
State:
Program:
Reset alarms
Reset alarms:
Heat pump schedule
Enable:
Day:
MONDAY
opy to:
MONDAY
NO
:
4:
ON
:
:
ON
3:
:
ON
4:
4:
OFF
Active demands
58
DHW schedule
Enable:
Day:
MONDAY
opy to:
MONDAY
NO
:
4:
ON 45
:
:
ON 55
3:
:
ON 4
4:
4:
OFF 
Night-time
Enable
min
Start:
3:
End:
7:
ompressor: 5%
Air Unit: 4%
3:
5/8 DHW
Enable:
Remote control:
ON
SetT
48
DTstart: 5
SetT HTR: 7
DHW
RealT:
479
3
SetT:
48
DTstart: 5
94
Start comp T:
43
/8
On/Off
Unit address:
State:
Program:
XXXXXX
Enable:


StopT:



4/8 ooling
Enable:
StopT:
Active: 8
Passive: 
XXXXXX schedule
Enable:
Day:
MONDAY
opy to:
MONDAY
NO
:
4:
ON 45
:
:
ON 55
3:
:
ON 4
4:
4:
OFF 
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ecoforest ecoGEO series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ecoforest ecoGEO series in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 9.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info