Manual Dremel 400seriesXPR (page 15 of 72) (English, French, Spanish)

25125

Zoom out

Zoom in

1/72

4. Install existing or new brushes so the

curved surface of the brush end match-

es the curvature of the motor commuta-

tor (as seen through the brush opening).

NOTE: The detent on the brass clip must fit

into the slot on the side of the brush pocket,

which secures the brass clip in the proper

position (Figure C).

5. Reinstall brush covers by angling the

non-clip end into the opening. Make cer-

tain brush spring is centered in the “V”

notch on the brush, then snap closed

the clip end of the brush cover.

6. Plug power cord into a wall outlet. Run

the rotary tool at full speed for 5 minutes

under no load. This will properly seat the

brushes and extend the life of the tool.

For questions or replacement brushes,

please call Dremel’s Consumer Service

1-800-437-3635

or check our website at www.Dremel.com.

Cleaning The Tool

Ventilation openings and switch levers must

be kept clean and free of foreign matter. Do

not attempt to clean by inserting pointed

objects through openings.

The tool may be

cleaned with com-

pressed air. Always

wear safety goggles

when cleaning tool

with compressed air.

There is no need to lubricate the Dremel™

rotary tool.

Certain cleaning agents

and solvents will damage

plastic parts. Some of these are: gasoline,

carbon tetrachloride, chlorinated clean-

ing solvents, ammonia and household

detergents that contain ammonia.

Clean the “soft grip” areas of the tool using a

damp cloth. Tougher soiled areas may

require more than one wipe application to get

clean.

CAUTION

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dremel 400seriesXPR in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 4,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dremel 400seriesXPR Manual

Product: