499396

Dr. Kern Atlantic Manual

18
Zoom out
Zoom in
Previous page
1/35
Next page
18
The drill holes in the bearing brackets of the upper section
with the plastic bearings now attached must now be
positioned to fit the drill holes in the bearing brackets of the
bed. The upper section is lifted slightly at the back in this
process (figure 6).
Now one bearing bush from the plastic bag is inserted in the
plastic bearing from the outside on both sides and tightened
with the screw DIN 912 M8x20 from the accessories bag
(figure 7).
The upper section is now connected to the bed on both
sides with a mobile joint.
Please ensure that the bearing brackets on the upper section
are positioned on the outside of the equipment in each case.
fig. 6
fig. 7
Assembly of the gas pressure springs
Now the gas pressure springs are assembled, which keep
the upper section in the open or closed position.
Security springs are clipped to each end of the gas pressure
springs, which are found as a separate unit in the packaging.
These springs must be removed as shown in figure 8.
fig. 9
fig. 10
Gas pressure
spring
Pin holes
Safety ring
Ball socket
System slot
fig. 8
In order to fit the gas pressure damper on the upper section
this is swung so far open that the ball sockets can be easily
pushed into the ball pins (figure 9).
As the side surrounds are removed you can see the ball
joint bar on the upper section and in the bed on the equipment
face, into which the joint socket of the gas pressure damper
is engaged.
The gas pressure springs must now be assembled to the
previously assembled ball pins on the bed and on the upper
section. Hold the gas pressure spring, as shown in figure
10, with the ball socket over the ball pin and then press the
ball socket onto the ball pin. Check if this connection has
been made properly by briefly pulling against the joint.
Defective assembly of the gas pressure dampers is not
possible as the gas pressure damper is fitted with different
sizes of joint sockets above and below. Despite this it should
be ensured that the pressure cylinder is on the top (figure
10).
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dr. Kern Atlantic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dr. Kern Atlantic in the language / languages: English, German, Spanish as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info