766055
7
Zoom out
Zoom in
Previous page
1/15
Next page
7
Turning ON
Transmitter
Plug the adapter connector in the socket on the back of the transmitter unit and plug in
the power outlet. You can power up the transmitter by the setting the switch to ”ON. The
green LED on the front panel will be lit and in the case that the antenna wire is not
connected, the red LED (Loop error) starts ashing on and o and the transmitter starts
sounding intermittently. After the antenna wire is connected, the LED will be steadily lit
and the transmitter stops sounding.
Receiver (collar)
Insertion (replacement) battery: Remove 4 screws from the receiver housing cover plate
using a cross-head screwdriver. Install a CR2 type 3V battery following the proper polarity,
indicated with the ”+“ sign on the PCB next to the battery compartment. A beep will
sound indicating that the collar is active. Make sure that the seal is in its correct place, i.e.
in the slot on the housing cover. To retain water-tightness, it is recommended to replace
this seal at least once a year. Replace the receiver housing cover and tighten reasonably
the 4 screws with the cross-head screwdriver.
Note:
After battery replacement the collar will remember the mode you selected previously.
Turning ON/OFF
Switching OFF
If the receiving collar is not used for a long period of time, the battery should be removed.
If you want to take your dog out of your piece of land, take o its receiving collar. You can
also turn o the transmitter by setting the switch to ”OFF. The green LED goes out.
Checking the battery status
There is an indicator LED on the front side of the
receiver.
Weak battery: the indicator LED is blinking in
red. Exchange the CR2 3V battery as descri-
bed in the user guide (chapter Turning ON/
OFF – Receiver)
Battery polarity sign
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-fence at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-fence in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info