766075

Dogtrace d-control professional 2000 Manual

10
Zoom out
Zoom in
Previous page
1/20
Next page
10
Switching the receiver ON / OFF
To turn the receiver ON / OFF ( or for programming the transmitter with the receiver)
is used a magnetic switch, marked with the red target on the receiver.
Switching ON
1. Move the red target of the transmitter
towards the receiver so it comes into
the contact with the red target of the
receiver. The red LED indicator of the
receiver will lit up, afterwards the
green LED indicator will lit up.
2. When the green LED lighted up, move
your transmitter away from the
receiver. The receiver LED indicator
will ash green to indicate the receiver
is ON.
Switching OFF
When switching OFF, follow the same steps as when switching ON.
1. Move the red target of the transmitter towards the receiver so it comes into the
contact with the red target of the receiver. The green LED indicator of the receiver
will lit up, afterwards the red LED indicator will lit up.
2. When the red LED is lighted up, move your transmitter away from the receiver. The
receiver LED indicators will stop ashing.
Important: When turning the receiver ON/OFF hold the red target of the receiver
close to the red target of the transmitter for about 1 second. When the targets are
close to each other for longer than 5 seconds the receiver will switch to the pairing
(programming) mode of the transmitter with the receiver. This programming
mode is indicated by alternate ashing of the red and green LED indicator. If this
occurs, follow the chapter Programming (pairing) the transmitter with the
receiver.
Programming (pairing) the transmitter with the receiver
Each transmitter has its own radio operational code. The programming of the
transmitter with the receiver enables those two units to work together. When
purchasing new d-control professional set, there is no need to program the device.
The set is programmed from the manufacture. In case you want to use another
transmitter or receiver, you need to program the devices together. Programming
The batterry is fully charged – when switched on, green LED is ashing.
The battery is low – when switched on, red LED is ashing.
When the battery is low or at, insert a new CR2 3V lithium battery into the receiver.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control professional 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control professional 2000 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info