766075

Dogtrace d-control professional 2000 Manual

12
Zoom out
Zoom in
Previous page
1/20
Next page
12
Choice of the contact points
The stimulation is transferred on your dog‘s skin through the steel contact points
of the receiver. Each set contains 2 types of contact points. Sucient length of the
contact points has to have a contact with the dog‘s skin, enabling the device to
operate correctly. If you have a short-haired dog use the 12 mm contact points, if
you have a long-haired dog replace them with the longer 17 mm contact points
supplied in the kit. Screw the contact points onto the screws of the receiver - see the
picture Receiver in the chapter Product description, page 7. Tighten them manually
carefully (do not use a pliers – this could damage the product).
TIP: If your dog has very long hair, you can order 21 mm long contact points.
When your dog has a dry skin in the area where the contact points are, it is good
to lubricate the dog‘s skin with a vaseline, hand cream, or baby oil - which enables
a correct transfer of stimulation impulses.
Fitting the collar
The strap (receiver collar) with the receiver collar must be tightened enough so that
the contact points are in contact with the skin of the dog. We recommend you to t
the collar on the standing dog. When you can t two ngers between the collar and
your dog‘s neck, the collar with the receiver are tightened enough. If a dog has long
or thick hair, it is suitable to trim the hair in the area of the contact points or to switch
to the longer contact points to ensure a consistent contact.
Warning: If the collar is too loose, the receiver is likely to move and repeating
friction can irritate the skin of your dog. Furthermore, in this case it is not ensured
a reliable contact of contact points with the skin and a proper function of the
training collar. We do not recommend to leave the collar positioned at the
same place for more than several hours, because it could irritate the skin. If it is
necessary to wear the collar for long periods, change regularly the position on the
neck of your dog. A collar with a receiver that is overly tight, can cause pressure
sores on the skin in the contact area of the contact points. If this happens, do not
use the training collar until all traces of irritation are gone.
Warning: If you program the receiver from the switched OFF status (see the
chapter Programming function buttons A1 / A2 with the rst receiver), the
device that was programmed from the switched ON status will be automatically
removed (mostly used to remove the trainer‘s transmitter from your receiver after
the training is nished).
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dogtrace d-control professional 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dogtrace d-control professional 2000 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info