28
To turn the appliance on again, you must insert the water spout (fig. 4), press the button and run off
water from the spout for a few seconds.
When using the appliance for the first time, 4-5 cups of coffee and a cappuccino need to be made
before the appliance starts to give satisfying results.
If the appliance malfunctions, do not contact the service centre straight away.
The problem can almost always be resolved by following the instructions indicated in paragraphs 18 and 19.
If this is not the case, or for further explanations, contact the customer service by calling the number listed on
the sheet enclosed on page pag.2.
If your country is not listed on the sheet, call the number indicated on the warranty.
7 CHANGING THE QUANTITY OF COFFEE IN THE CUP
The appliance is factory preset to automatically deliver the following quantities of coffee:
- short coffee (40 ml) (when the button is pressed);
- normal coffee (80 ml) (when the button is pressed);
- long coffee (120 ml) (when the button is pressed);
To change these quantities, proceed as follows:
- press the button corresponding to the quantity you want to change ( , or ) for at least 8
seconds then release until the message "PROGRAM QUANTITY" is displayed and coffee is delivered;
- when the coffee in the cup reaches the required level, press the same button again to memorise the new
amount.
The appliance is now re-programmed with the new settings and displays: READY.
8 REGULATING THE COFFEE MILL
The coffee grinder is preset in the factory to prepare coffee correctly and should not require regulating ini-
tially.
However, after making the first coffees, if you find that coffee delivery is either too fast or too slow (in drips),
the grinding coarseness regulator can be adjusted (fig. 12).
Turning it 1 click (1 number) clockwise speeds up coffee delivery (without drips).
Turning 1 click anticlockwise slows down delivery giving a creamier appearance to the coffee.
These adjustments will only be evident after at least 2 cups of coffee have been run off.
The grinding coarseness regulator must only be turned when the coffee mill is on.
Turn one click anticlockwise to obtain slower delivery and a
creamier appearance (finer ground coffee).
Turn one click clockwise for faster delivery (not a drop at a time)
(coarser ground coffee).
(Coffee has been used to factory test the appliance and it is therefore completely normal for there to be
traces of coffee in the mill. This appliance is however guaranteed to be new).
