37
18 MEANING OF MESSAGE DISPLAYED AND WHAT TO DO
ADD PRE-GROUND COFFEE
• With the function selected, the pre-
ground coffee has not been poured into
the funnel.
• Add the ground coffee as described in
section 9.
FILL BEANS CONTAINER
• The coffee beans have run out.
• If the coffee grinder is very noisy, this
means a small stone in the coffee beans
has blocked the mill.
• Fill bean container
• Contact an authorised De' Longhi servi-
ce centre.
DESCALE
• This indicates the presence of lime scale
in the appliance.
• The descaling procedure, described in
section 16.3, needs to be performed as
soon as possible.
PRESS NEXT CHANGE
• After cleaning, the infuser has probably
been left out of the coffee maker.
• Leave the service door closed and the
infuser out of the appliance, then follow
the instructions displayed.
CLOSE DOOR
• The service door is open • If the service door cannot be closed,
check that the infuser is inserted cor-
rectly (section 15.2 - note 1)
MESSAGE MEANING WHAT TO DO
FILL TANK
• The water tank is empty or is positioned
incorrectly.
• The tank is dirty or encrusted with lime
scale.
• Fill the water tank as described in sec-
tion 6, note 6 and insert it fully.
• Rinse or descale the tank.
GROUND TOO FINE / ADJUST
MILL AND /
• The appliance cannot make coffee • Insert the hot water spout, press the
button and run off water from the spout
for a few seconds.
INSERT WATER SPOUT AND /
PRESS OK
• The coffee runs off too slowly. • Turn the grinding regulator (fig. 12) one
click clockwise (see section 8).
EMPTY GROUNDS / CONTAINER
• The grounds container is full or missing. • Empty the grounds container and clean
as described in section 6, note 7, then
replace.
INSERT GROUNDS / CONTAINER
• After cleaning, the grounds container
has not been replaced.
•Open the service door and insert the
grounds container.
INSERT INFUSER ASSEMBLY
• After cleaning, the infuser has probably
been left out of the coffee maker.
• Insert the infuser, see section 15.2
INSERT THE WATER SPOUT
• The button has been pressed and the
hot water spout has not been inserted.
• Insert the hot water spout (fig. 4)
