481717
43
Zoom out
Zoom in
Previous page
1/76
Next page
42
De Dietrich Gas 310/610 ECO
10.0 COMMISSIONING
Warning:
If you do not follow the commissioning instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
10.1 Initial lighting
1. Isolate main power supply
2. Remove the casing on the inspection side.
3. Open the main gas valve.
4. Check the electrical connections including
earth.
5. Fill the boiler and the system with water
(approximate > 11 psi).
6. Vent all air from the system.
7. Fill the siphon assembly with water.
8. Check the flue gas discharge connection
and air inlet duct or air supply connections.
9. Vent the gas pipe, Open the gas cocks to
the boiler.
10. Check the inlet gas pressure PI (see fig.
23). Ensure sufficient gas supply pressure
> 3.5 w.c.
11. Check the gas connections for gas leaks.
12. Switch on the main power supply to the
boiler.
13. Switch on the boiler operating switch.
14. Switch on the heating pump and check the
installation position and direction of
rotation.
15. Adjust the boiler controls to heat demand.
16. The boiler should start with the run
sequence indicated in the code-display:
= Boiler neutral position (No heat
demand)
= Butterfly valve open, if connected;
Wait for minimum gas pressure switch to
close: Neutral position check of air
pressure differential sensor; Vent damper
opens (if applicable); The fan runs and the
boiler waits until sufficient air transport is
established; the air pressure differential
sensor must switch to guarantee sufficient
airflow.
= Gas valve leak proving system test
(Only if option employed)
= Pre-purging, drives to high fire position
= Heating pump starts running; drives to
ignition position.
= Burner is firing a flame is detected
Fig. 23 Gas valve (multiblock) adjustments – Artist impression
Fig. 24 flue gas measuring point
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich Gas 310 ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich Gas 310 ECO in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info