481717
41
Zoom out
Zoom in
Previous page
1/76
Next page
40
De Dietrich Gas 310/610 ECO
8.8.5 Return butterfly valve 3-way valve (supplied by others)
A butterfly valve should be installed in return for each boiler module is hydraulically disconnected from the
system. The return butterfly valve is fully open the valve end switch contact is closed, allowing the boiler
to run. The return butterfly valve must be connected to terminals X21-11 (neutral), X27-12 (power close)
and X27-13 (power open) on the 120-volt terminal strip. The end switch on the return butterfly valve must
be connected to the external interlock terminals X29-3 and X29-4 (first remove bridge). After boiler shut-
off, the power supply will remain on X27-13 keeping the valve open during the post purge time of the
pump (set point code , then switch to X27-12 to close the valve (this remains valid even if no pump has
been connected to the control box. (also see sections 8.9.1 & 13.1.2
Please refer to the document supplied with the return of 3-way valve for detailed installation
information.
8.9 Other connections
8.9.1 Boiler or System pump control
The Gas 310/610 ECO a power supply (120V max 2amps) to run or control an external boiler or system
pump. The boiler control will run the pump once every 24hrs when the boiler not enabled to prevent
sticking and will also provide a run on period at the end of a heat demand (parameter , see section
13.1.2)
Important!! Phase/Neutral sensitive!
Important!! For multiple boiler installations the system pump cannot use this power supply.
If the boiler shuts down the system pump will also shutdown.
8.9.2 Frost protection
The boiler must be installed in a frost-free area to prevent freezing of the condensate drain.
If the temperature of the heating water drops too low the integrated boiler protection activates under the
following conditions.
If the boiler flow temperature:
Is below 44°F [7°C], the external heating pump connected to the boiler is switched on at
minimum capacity:
Is below 39°F [3°C] the boiler is switched on at minimum capacity;
Exceeds 50°F [10°C], the boiler and heating pump are switched off again. The pump now
has a fixed post-circulation time of 15 minutes.
Important!!
This frost protection only protects the boiler. Other measures must be employed to protect the
building and system and will depend which parameters are set or what form of external controls
are in use.
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich Gas 310 ECO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich Gas 310 ECO in the language / languages: English as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info