362104

Clatronic kav 3002 Manual

56
Zoom out
Zoom in
Previous page
1/178
Next page
56
Cleaning and maintenance
If it is not possible to clean the filters sufficiently using the
aforementioned procedure, then it would be a good idea to dismantle
the filters:
1. Release the filters with a crosshead screwdriver.
2. Take the filters out of their holders.
3. Hold the filters against the light. Now you will see which filter
holes are blocked.
4. Clean the blocked holes carefully using the tip of a needle.
5. Place the filters back into the holders.
6. Tighten the screws again carefully.
Adjusting the drive shaft If the brew unit cannot be inserted correctly, then the coupling of the
drive shaft has probably not clicked into place correctly.
Proceed as follows:
1. Remove the brew unit from the machine >Page 54, "Cleaning
the brew unit"/Points 1-2.
2. Close the service door (Fig. 20/1).
3. Connect the machine to an earthed socket again.
4. Switch the machine off and on again.
Now re-adjust the drive shaft. This process lasts about 20
seconds.
5. You now see the message "Warning, insert brew unit".
6. Place the brew unit back into the machine >Page 54, "Cleaning
the brew unit"/Points 6-7.
7. As long as the brew unit can be replaced easily: Switch the
machine on. It is now ready to start.
Adjust filter holder in brew unit
If the brew unit can still not be inserted, the position of the filter holder
in the brew unit must be checked and if necessary adjusted.
1. Switch the machine off.
2. Remove the brew unit from the machine >Page 54, "Cleaning
the brew unit"/Points 1-2.
3. Check the starting position of the brew unit. The guide pin on the
filter holder (Fig. 26/1) should be approx. 10 mm away from the
lower limit when in the starting position (Fig. 26/2).
The distance must be altered if it is too small or too large.
1
Fig. 25
WARNING:
Danger of injury: Before adjusting the drive shaft, turn the machine
off and remove the mains plug. Wait until the machine and
accessories have cooled down.
WARNING
INSERT
BREW UNIT
10 mm
1
2
Fig. 26
… 56 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic kav 3002 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic kav 3002 in the language / languages: English, German, Dutch, Italian, Polish, Spanish as an attachment in your email.

The manual is 8,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info