667040

Celestron CGE Pro 925 Manual

9
Zoom out
Zoom in
Previous page
1/72
Next page
9
A
A
t
t
t
t
a
a
c
c
h
h
i
i
n
n
g
g
t
t
h
h
e
e
M
M
o
o
t
t
o
o
r
r
C
C
a
a
b
b
l
l
e
e
s
s
1. Locate the two motor cables. The longer cable attaches to the DEC motor while the shorted cable attaches to the RA
motor.
2. Insert one end of each cable into the designated port on the electronic pier.
See figure 2-5.
3. Attach the other end of the longer cable to the port on the side of the DEC
motor and the shorter cable into the port on the RA motor.
4. Thread the cable ring onto each port to hold the cable securely in place.
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
t
t
h
h
e
e
C
C
o
o
u
u
n
n
t
t
e
e
r
r
w
w
e
e
i
i
g
g
h
h
t
t
B
B
a
a
r
r
To properly balance the telescope, the mount comes with a counterweight bar
and at least one counterweight (depending on model). To install the
counterweight bar:
1. Locate the counterweight bar from the box containing the CGE Pro
mount (see Fig 2-6).
2. Thread the counterweight bar through the end of the declination shaft
until tight.
Once the bar is securely in place you are ready to attach the counterweight.
Since the fully assembled telescope can be quite heavy, position the mount so that the polar axis is pointing towards
north before the tube assembly and counterweights are attached. This will make the polar alignment procedure much
easier.
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
t
t
h
h
e
e
C
C
o
o
u
u
n
n
t
t
e
e
r
r
w
w
e
e
i
i
g
g
h
h
t
t
Depending on which telescope model you have, you will receive either one, two or three counterweights. To install the
counterweight(s):
1. Orient the mount so that the counterweight bar points toward the ground
2. Remove the counterweight safety screw on the end of the counterweight
bar (i.e., opposite the end that attaches to the mount).
3. Loosen the locking screw on the side of the counterweight.
4. Slide the counterweight onto the shaft (see Fig 2-6) until they are in the
center of the bar.
5. Tighten the locking screw on the side of the weight to hold the
counterweight in place.
6. Replace the counterweight safety screw.
DEC Motor
RA Motor
Dec Port
RA Port
Figure 2-5
Figure 2-6 – Mount shown with two
counterweights
Safety
Screw
Counterweights
Counterweight
Bar
Locking Screws
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Celestron CGE Pro 925 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Celestron CGE Pro 925 in the language / languages: English as an attachment in your email.

The manual is 3,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info