636455
29
Zoom out
Zoom in
Previous page
1/36
Next page
DIGISTAT
INSTALLATION
DIGISTAT / DT10RF RECEIVER
MOUNTING THE DIGISTAT
Positioning RF room thermostats
The Digistat is a radio frequency device which is
very flexible for positioning as there is no need for
hard wiring to the appliance. The device should be
mounted in a open area, no closer than 30cm from
metal objects, including wall boxes.
Mount the Digistat on a wall which is not subject to
direct sunlight or draughts, preferably on an inside
wall, 1.5 metres above the floor. The Digistat must
also not be directly influenced by radiators or other
appliances giving off heat.
1. Remove the front cover using a flat screwdriver
and separate from back plate.
Mounting the digistat
Digistat
To cancel signal strength mode:
1. Remove the batteries from the transmitter to
cancel the constant transmission.
2. After a few seconds the receiver display will
show ‘---’ .
3. Press ‘OK’ on the receiver display and the display
will return to the time with the ‘CH and Antenna’
flashing.
4. Re-insert the batteries into the transmitter and the
RF link will be re-established.
2. Fix the back plate directly onto the wall using
suitable wall plugs and screws.
DT10RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 493a (02.2009)
OPERATING & INSTALLATION
INSTRUCTIONS
25
8_716_115_493a 9/2/09 09:46 Page 29
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch DT10RF DIGISTAT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch DT10RF DIGISTAT in the language / languages: English as an attachment in your email.

The manual is 4,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info