636455

Bosch DT10RF DIGISTAT Manual

30
Zoom out
Zoom in
Previous page
1/36
Next page
DIGISTAT
INSTALLATION
DIGISTAT / DT10RF RECEIVER
TO CHECK PREVIOUSLY
INSTALLED UNIT
3. Replace the front cover by locating in position and
pushing fully onto the back cover.
To check signal strength on previously
installed and paired units :
1. Press the ‘set’ button 4 times.
2. Press ‘OK’ once.
3. Press the ‘set’ button 5 times. The display will
show ‘SSI and OFF’.
4. Press the ‘+’ button so that the display shows
‘SSI, Antenna and ON’.
5. Press the ‘set’ button so the display shows ‘SSI
and Antenna’.
6. After a few seconds the display will show ‘---’.
7. Remove the batteries from the transmitter and wait
until the display has faded away.
8. Press and hold the ‘+’ button on the transmitter
while re-inserting the batteries and keep the
button depressed until the display shows ‘rF’ .
OPERATING & INSTALLATION
INSTRUCTIONS
DT10RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 493a (02.2009)
26
8_716_115_493a 9/2/09 09:46 Page 30
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch DT10RF DIGISTAT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch DT10RF DIGISTAT in the language / languages: English as an attachment in your email.

The manual is 4,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info