636455
28
Zoom out
Zoom in
Previous page
1/36
Next page
Digistat
DIGISTAT
INSTALLATION
DIGISTAT / DT10RF RECEIVER
SETTING UP THE RF LINK
Signal strength indicators
Transmitter code
(may be different)
LED indicator shows different colour depending
on signal strength (see table below)
3. The symbols on the receiver will stop flashing and
the display will show ‘SSI, Antenna and ON’.
4. Press ‘SET’ and the display will show ‘SSI and
Antenna’.
5. After a few seconds the display will show ‘- - -’.
6. Remove the batteries from the transmitter and
wait for the display to fade. Press and hold the ‘+’
button while re-inserting the batteries and keep
the button depressed until the display shows ‘rF’.
The transmitter is now in constant transmission
mode enabling it to be correctly positioned within
the home.
7. The receiver display will now show the ‘learnt’
transmitter code and the antenna’ as well as the
signal strength as indicated by the chevrons on
the right hand side of the display.
8. Place the transmitter in the desired final position
and return to the boiler to check the receiver
display. The ideal transmitter position will result in
the receiver display showing 4 chevrons and the
LED will be green. For siting advice please refer
to “Positioning RF room thermostats” on page 25.
9. If the LED is red or no LED is showing and the
display indicates 1 or 2 chevrons, the transmitter
will need to be re-positioned until the LED
changes to amber or green and 3 or 4 chevrons
are indicated on the display.
NOTE: If there is no LED and the display shows
‘- - -’, there is no signal being received at all from
the transmitter. Transmission will resume once the
transmitter is re-positioned in a part of the house
where an amber or green LED and 3 or 4
chevrons are achieved.
10. Once you are happy that, when in the desired
location, the transmitter is sending a good signal
to the receiver i.e. amber or green and 3 or 4
chevrons, the transmitter can be fixed to the wall.
LED Indication Chevrons RF Strength
Green
Amber
Red
None
4
3
2
1
Very strong
Strong
Weak
Very weak
OPERATING & INSTALLATION
INSTRUCTIONS
DT10RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 493a (02.2009)
24
8_716_115_493a 9/2/09 09:46 Page 28
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch DT10RF DIGISTAT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch DT10RF DIGISTAT in the language / languages: English as an attachment in your email.

The manual is 4,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info