693646

Benekov S100 Manual

25
Zoom out
Zoom in
Previous page
1/30
Next page
In the event of any damage to electrical equipment, the boiler must be shut down,
unplugged from the mains and a qualified repair must be undertaken;
It is forbidden to interfere with the wiring of safety circuits, or perform any unauthorized
interventions, which are related to the equipment’s safety and reliability.
b) Thermal risks
The boiler must not be exposed to higher working pressures than prescribed;
It is forbidden to overheat the boiler;
The boiler must be protected against low-temperature corrosion by a suitable
connection with an automatic return temperature protection;
The boiler can burn only specified fuel;
It is prohibited to store flammable liquids near the boiler;
Minimize the risk of ignition by setting suitable attenuation parameters;
During boiler operation pay maximum attention to the risk of burns from sources of
heat.
c) Risks posed by fuel handling
Handling fuel results in emission of solid particles. Therefore, the operator should wear
appropriate protective equipment according to the degree of dust generation;
Because it is a fuel, it is necessary to observe appropriate fire regulations and keep a
suitable portable fire extinguisher accessible.
d) Ergonomic risks
The boiler must stand horizontally in the boiler room;
It is forbidden to put hands into the screw feeder;
All doors, lids and covers must be completely closed during boiler operation.
8. Boiler maintenance
NOTE: Before performing maintenance and cleaning the boiler and/or feeder mechanism, it is
necessary to make sure the boiler is disconnected from the power supply (plug pulled out of
the socket). Risk of injury!
1.) It is necessary to ensure timely refuelling. If a small amount of fuel remains in the
container, it must be refilled immediately to prevent extraction of "false air" and a smoked
container.
Ensure proper closing of the fuel container cover.
2.) If the boiler is correctly adjusted, the ash has the form of a fine grey powder, which
accumulates in the ash tray drawer. The combustion compartment has self-cleaning design
and in the course of normal operation the boiler’s ash tray drawer has to be emptied once a
week. It is necessary to use protective gloves for this activity.
3.) In continuous operation of the boiler it is recommended to clean the heat transfer surface
of the boiler body once a month. The heat transfer surfaces can be subject to clogging,
which can greatly affect the heat transfer and thus the efficiency of the boiler. Occasional
cleaning of the inside of the grate (on a monthly basis) should not be forgotten. Its clogging
impairs the flow of combustion air to the burner nozzles. The boiler must be shut-off by the
main switch at least 1 hour before cleaning the grate. After the heating season the entire
boiler must be carefully and completely cleaned.
4.) The minerals contained in the wood pellets can form hard deposits during operation in the
area of the furnace. This can subsequently cause a complete blockage of the screw shaft of
the feeding mechanism. To avoid the risk of this phenomenon, it is recommended to check
the burner zone at least monthly and in the event of hard deposits on the grate,
mechanically remove the grate and any stuck material.
5.) It is further recommended to perform occasional external cleaning of drives and fans.
Cleaning must be done using a dry brush. The boiler must be disconnected from the power
supply during this time.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benekov S100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benekov S100 in the language / languages: English as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info