693645
24
Zoom out
Zoom in
Previous page
1/32
Next page
The worm gear is worn out. Change the worm gear.*
The cable of the ventilator
has been disconnected /
damaged.
Connect (change) the cable to the
ventilator.*
The boiler ventilator
doesn’t work.
The ventilator is broken. Change the ventilator.*
The ventilator is full of dust.
Clean the ventilator.* The ventilator is
noisy.
The ventilator bearing is
worn out.
Change the whole ventilator.*
During the boiler
modulation at the
lowest output, the
ventilator does not
turn.
The set values of ventilator
speed (revolutions) are too
low.
Increase the values of the ventilator turns
so that continuous operation of the
ventilator is ensured.
The water from the
emergency
extinguishing system
runs in the fuel
container.
The fuel has burnt off in the
fuel container and the
thermostatic valve was
opened.
Remove the wet fuel from the boiler, refill
the container with the new fuel and put the
boiler into the operation.
The water from the
emergency
extinguishing system
drops in the fuel
container.
The paraffin plug is not
tight.
Change the thermostatic valve.
Wet fuel is used in the
boiler.
Fill the container with dry fuel. Water drops appear
on the walls of fuel
container.
Low temperature in the fire
room (12°C and less).
It is necessary to ensure higher
temperature of the fire room (insulation of
fire room walls, installation of a heating
body in the fire room etc.)
The time from the firing was
too short.
Let the boiler fire up properly.
The fuel dosage is adjusted
to a lower capacity.
Set up the fuel dosage according to the
manual to the Instruction Control Unit.
The boiler can’t reach
the full nominal
capacity.
Different fuel than
recommended was used
(high humidity, lower
heating power etc.).
Fill the container with appropriate fuel.
The boiler is coated with
smoke particles.
Clean the heat transfer surfaces
The boiler is overheated. Adjust the fuel dosage according to the
Instruction Control Unit manual.
The exhaust gas
temperature is higher
than is recommended
in the user’s manual.
High chimney draught. Install a draught limiter at the chimney (this
activity can be maintained by the service
company only).
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benekov R100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benekov R100 in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info