693645

Benekov R100 Manual

22
Zoom out
Zoom in
Previous page
1/32
Next page
it is forbidden to overheat the boiler
the boiler must be protected from corrosion caused by low temperature of returning water by
means of a suitable connection with automatic temperature control of returning water
only listed fuel can be combusted in the boiler
it is forbidden to store combustible materials near the boiler
it is necessary to minimize the risk of ignition of the fuel container by suitable setting of
attenuation parameters
when operating the boiler, it is necessary to pay maximum attention to heat sources as they may
cause burns
c) Risks connected to manipulation with fuel
during manipulation with fuel, solid particles are emitted. Therefore, the operator should,
depending on the degree of dustiness, use suitable protective equipment.
because of the risks connected to manipulation with fuel, it is necessary to comply with
applicable fire regulations and a fire extinguisher must be available
d) Ergonomic risks
the boiler must be in a horizontal position
it is forbidden to insert hands in the worm conveyor
during operation of the boiler, all doors, covers and guards must be closed properly
8. Boiler maintenance
1.)
It is important to refill the fuel in time. As soon as there is only a small amount of fuel in the
container, it must be refilled immediately to prevent false air or smoke from entering the container.
ATTENTION: The lid of the fuel bin must be closed properly.
2.) If the boiler is well-adjusted, the ash appears in the form of a fine powder which falls in the ashtray.
As the combustion area has a self cleaning function, the ashtray needs to be emptied only once a
week during regular operation. Use protective gloves for this activity.
3.) If the boiler runs continuously, it is recommended to clean the heat transfer surface of the body of
the boiler once a month. The heat exchange surfaces become contaminated in course of the
operation, which may significantly impair the heat transfer and the efficiency of the boiler.
It is also important to clean occasionally (once a month) the inner part of the grate as any possible
sediments influence negatively the flow of air in the burner nozzles.
It is recommended to shut down the boiler (switch off the main switch) at least 1 hour before
cleaning of the inner part of the grate is carried out. After the heating season the boiler must be
completely cleaned.
4.) Minerals contained in the wooden pellets can form crusts on the grate, which may lead to a
complete blockage of the worm-gear-system. To avoid this it is recommended that the burner area
be checked at least once a month and any hard sediment on the grate be removed manually.
5.)
Further, it is recommended that the outside of the gear engine and the ventilator be cleaned with a
dry brush from time to time. During the cleaning, the boiler must be disconnected from the
electrical power.
6.) A heat-resistant ceramic reflector and ceramic plates are installed over the burner. There is no
special care demanded. Ash may appear on the surface of the reflector, which can be removed, but
it does not impair the function of the device.
7.)
The engine is protected against damage with a thermo contact that ensures the protection against
burn off especially if the feed device becomes blocked (regular temperature of the engine can
reach 85°C). In case of overheating (if the critical temperature was exceeded) the thermo contact
shuts down the engine and the ventilator. In such a case, it is necessary to switch off the boiler, clear
the fuel from the container via the discharging gap and eliminate the fault. WARNING: before
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benekov R100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benekov R100 in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info