693645

Benekov R100 Manual

21
Zoom out
Zoom in
Previous page
1/32
Next page
• When fuel is transported to the combustion chamber before ignition, it is necessary
to perform a visual check only. Inserting hands in the worm feeder is forbidden as it may
result in injury!
• It is forbidden to use flammable liquids for firing.
• If boiler uses the automatic ignition it is necessary to keep the fuel level in the fire
grate before the ignition process max. at the same level as upper rim of fire grate and the fuel
cannot cover the ignition tube. In any case there could be the danger of explosion inside the
combustion chamber.
• The fire in the boiler may be observed through the control window in the upper part
of the fire door. If it is necessary to open the door during the operation of the boiler (for
example when the ash has to be removed from the ashtray) please keep in mind that it means
an increased risk of sparks and smoke being released into the fire room. In such case the
door must be closed immediately and properly. Opening of the door during operation must be
done carefully, that means to open it slightly, wait until the combustion products release from
the combustion chamber and only then open it fully.
• During the operation of the boiler, it is necessary to keep the container closed.
• The fuel in the container must not reach higher than 30 mm under the lower rim of the
filling gap to ensure proper closing of the container.
• It is strictly forbidden to overheat the boiler.
• It is forbidden to lay flammable objects on the boiler or next to it closer than the
prescribed safe distance (see chapter 5.2.).
• During cleaning of the ashtray, no flammable materials should be within 1500 mm of
the boiler. The ash has to be stored in non flammable bins with a cover.
• During the operation of the boiler at temperatures lower than 60°C, the iron boiler
body grows damp and low temperature corrosion occurs which shortens the service life of
the boiler. That’s why the boiler must be operated at the temperatures higher than 60°C.
• After the end of the heating season the boiler and the chimney must be cleaned
carefully. The fire room must be kept clean and dry.
• It is strictly forbidden to tamper with the construction and electrical system of the
boiler.
7.4. Residual risks and their prevention
The risks connected to regular operation of the boiler as well as to logically foreseeable incorrect
operation was minimalized using available technical solutions.
Despite the technical and construction-related measures carried out, the operation of the boiler bears
residual risks determined by means of a risk analysis. These risks are the result of the technological
process during different phases of the device service time.
In particular, these risks are a result of carelessness during boiler attendance or a failure to
comply with the safety instructions during operation.
To further decrease these risks and make the operation even safer, the following list contains an
overview of residual risks which no technical solution can remove.
a) Electrical risks
connection, maintenance and repair of electrical parts of the boiler can be carried out only by
qualified workers and in compliance with current technical regulations and standards
power supply installation must be in line with the current regulations
the power cord and boiler electrical installations must be checked regularly and kept in a proper
state
if any damage occurs to the electrical equipment, it is necessary to shut down the boiler,
disconnect in from the power supply and provide qualified service
it is forbidden to tamper with the connections of the safety circuits or carry out any unauthorized
changes that could have impact on safety and reliability of the device
b) Heat risks
the boiler must not be subjected to a higher working overpressure than stated
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Benekov R100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Benekov R100 in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info