758290

Batavia BT-CS015 - 7062848 Manual

11
Zoom out
Zoom in
Previous page
1/50
Next page
9
English
• Be careful when cutting wood with
knots, nails or cracks in it and/or dirt on
it, as these can cause the blade to get
stuck.
• Never leave the circular saw
unattended.
• Use this circular saw to saw only wood
or wood-like products.
5. Using the machine
• Use clamps or a vice to hold the work.
• Never remove wood chips and saw dust
that is close to the saw blade with your
hands. If there are small pieces of wood
left between the xed and the movable
parts, the circular saw will have to be
stopped. The plug needs to be removed
from the socket, before any left piece
can be removed.
• Check that the blade is suitable for the
spindle speed of the circular saw. Do
not attempt to cut before the circular
saw has reached full speed. Make sure
the circular saw runs without load (i.e.
is not in contact with the work) when
you switch it on. The circular saw must
have reached its full speed rst.
• Never cut wood that is thicker than the
depth of the saw blade.
• When cutting in wooden walls or floors,
check there is no wiring or piping where
you intend to cut.
• Switch off the tool and wait until the
blade has stopped completely before
moving the saw away from the work or
putting it down. Hearing protection
should be worn when using circular
saw.
Switch off the machine immediately when
you discover:
• A defective mains plug or mains lead;
• A defective switch.
• Overheating of the circular saw.
• Smoke or odour caused by scorched
insulation.
6. Laser
6.1 Safety instructions for the laser cut-
ting guide
a. Do not point the laser beam at persons
or animals and do not look into the
laser beam. This laser emits a laser
beam that falls under laser class 2 in
accordance with EN 60825-1:2014. You
could blind people with it.
b. A laser is not a toy and does not
belong in the hands of children. Using
it incorrectly may result in irreparable
damage to the eyes.
c. It is forbidden to manipulate the laser
so as to increase its power in any way.
No liability will be assumed for any
damages caused as the result of fail-
ure to comply with these safety
instructions.
d. The laser does not contain any ser-
viceable parts. Therefore, do not open
the housing. Otherwise, you will ren-
der the warranty void.
e. Warning! Do not swap the laser with
another type of laser. Only the manu-
facturer of the laser or an authorised
representative may perform repairs.
f. Do not point the laser beam towards
highly reflective surfaces.
g. Do not insert any hard objects in the
laser optics.
h. Clean the laser optics with a soft, dry
cloth.
7. Electrical safety
Always check that the voltage of
the power supply corresponds to
the voltage on the rating plate.
• Do not use the machine if the mains
cable or the mains plug is damaged.
• Only use extension cables that are suit-
able for the power rating of the machine
with a minimum thickness of 1.5 mm2.
If you use a extension cable reel, always
fully unroll the cable.
7062848-Circular_Saw_1400W-Ma-1803-19.indb 9 20-03-18 10:39
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Batavia BT-CS015 - 7062848 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Batavia BT-CS015 - 7062848 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info